Filter
Top Products
133 En
USING MULTI-ZONE CONFIGURATION
ADVANCED
OPERATION
• Select TUNER as the input source to use the TUNER
features in the selected zone. For details about the
TUNER operations, see “FM/AM TUNING” on
page 56.
• Select XM as the input source to use the XM Satellite
Radio features in the selected zone. For details about
the XM Satellite Radio operations, see “XM
SATELLITE RADIO TUNING” on page 63.
The selected input source is shared across all zones.
y
• You must complete this step within 5 seconds while the selected
zone flashes in the front panel display. Otherwise, the currently
selected zone mode is automatically canceled. In this case, press
ZONE CONTROLS on the front panel again.
• When a video monitor is connected to one of the ZONE VIDEO
jacks, you can display the control information of Zone 2 or
Zone 3 and XM Satellite Radio information on the video
monitor screen. Set “Zone OSD” to “Zone2&Zone3” or
“Zone2” (see page 112).
■ Adjusting the volume level of Zone 2 or
Zone 3
Rotate VOLUME on the front panel (or press
VOLUME +/– on the remote control) to adjust the
volume level of the selected zone.
y
Press MUTE on the remote control to mute the sound output to
the selected zone.
When you use the external amplifiers in Zone 2 or Zone 3,
VOLUME +/– can be used only when “Zone2 Volume” or
“Zone3 Volume” is set to “Variable” in “Zone2 Set” or “Zone3
Set” (see page 113).
■ Adjusting the balance of the speaker
level in Zone 2 or Zone 3
Press TONE CONTROL repeatedly to select
“BALANCE” and then rotate PROGRAM on the
front panel to adjust the balance of the front left
and right speaker level of the selected zone.
■ Adjusting the tonal quality of Zone 2 or
Zone 3
Set the operation mode selector to AMP and then
press CH +/– on the remote control to adjust the
high-frequency response (TREBLE) or
TV VOL +/– to adjust the low-frequency response
(BASS) respectively.
y
You can also adjust the tonal quality of Zone 2 or Zone 3 by using
TONE CONTROL on the front panel. For details, see “Adjusting
the tonal quality” on page 52.
Check that “ZONE 2” or “ZONE 3” is displayed in the display
window of the remote control before you adjust the tonal quality
of the corresponding zone (see page 132).
Note
INPUT
TV
SOURCE
AMP
or
V
-
AUX/DOCK
DTV
DVR/VCR 2
VCR 1
DVD
CBL/SAT
MD/TAPE
CD-R
PHONO
TUNER CD
MULTI CH IN
NET/USB
(U.S.A. model)
+
–
VOLUME
VOLUME
or
Note
Note
CONTROL
TONE
PROGRAM
–
+
TV VOL
+
–
CH
TV
SOURCE
AMP
TREBLE
BASS