Yamaha RX-V2700 Stereo Receiver User Manual


 
CONTROLS AND FUNCTIONS
7 En
INTRODUCTION
8 MULTI ZONE buttons
ZONE 2 ON/OFF
Turns on Zone 2 only or sets it to the standby mode
(see page 131).
ZONE 3 ON/OFF
Turns on Zone 3 only or sets it to the standby mode
(see page 131).
These buttons are operational only when MASTER ON/OFF
is pressed inward to the ON position.
ZONE CONTROLS
Switches the zone you want to control between the
main zone, Zone 2 and Zone 3 (see page 131).
y
After you press ZONE CONTROLS, the indicator for the
currently selected zone flashes in the front panel display for
approximately 5 seconds. While the indicator is flashing,
perform the desired operation.
9 Front panel display
Shows information about the operational status of this unit
(see page 12).
0 ENHANCER
Turns on or off the Compressed Music Enhancer mode
(see page 54).
A Remote control sensor
Receives signals from the remote control (see page 11).
B NIGHT
Turns on or off the night listening modes (see page 55).
C PURE DIRECT
Turns on or off the Pure Direct mode (see page 52).
D PROGRAM selector
Selects sound field programs (see page 46).
Adjusts the bass/treble balance in conjunction with
TONE CONTROL (see page 52).
E OPTIMIZER MIC jack
Use to connect and input audio signals from the supplied
optimizer microphone in the “Auto Setup” procedure (see
page 35).
F PHONES jack
Outputs audio signals for private listening with
headphones (see page 43).
G VIDEO AUX jacks
Input audio and video signals from a portable external
source such as a game console or a video camera
(see page 29).
y
To reproduce the source signals input at these jacks, select
“V-AUX” as the input source.
The audio signals input at the DOCK terminal on the rear panel
take priority over the ones input at the VIDEO AUX jacks.
H USB port
Use to connect a USB memory device or a USB portable
audio player (see page 81).
I VOLUME
Controls the output level of all audio channels.
y
This does not affect the AUDIO OUT (REC) level.
Opening and closing the front panel
door
When you want to use the controls behind the front panel
door, open the door by gently pressing on the lower part of
the panel. Keep the door closed when not using these
controls.
Note
Note
To open, press gently on the lower part of the panel.