Filter
Top Products
123 En
REMOTE CONTROL FEATURES
ADVANCED
OPERATION
5 Press and hold the button you want to
program on the other remote control until
“OK” appears in the display window on the
remote control.
“NG” appears in the display window on the remote
control if learning was unsuccessful. In this case, start
over from step 4.
y
• If you want to program another function, repeat steps 4
and 5.
• If you continuously want to program another function for
another component, press SELECT k / n to select the
component, and then repeat steps 4 and 5.
6 Press LEARN again to exit the learning
mode.
• “ERROR” appears in the display window on the remote control
if you press a button not indicated in the respective step, or
when you press more than one button simultaneously.
• This remote control can learn approximately 200 functions.
However, depending on the signals learned, “FULL” may
appear in the display before you program 200 functions. In this
case, clear unnecessary programmed functions to make room
for further learning.
• Learning may not be possible in the following cases:
– when the batteries in the remote control for this unit or other
components are weak.
– when the distance between the two remote controls is too
great or too small.
– when the remote control infrared windows are not facing each
other at the appropriate angle.
– when the remote control is exposed to direct sunlight.
– when the function to be programmed is continuous or
uncommon.
You can change the name of the input source that appears
in the display window on the remote control if you want to
use a different name than the factory preset. This feature is
useful when you have set an input area to control a
different component.
1 Set the operation mode selector to AMP or
SOURCE and then press an input selector
button to select the input area you want to
rename.
The name of the selected input area appears in the
display window.
2 Press RENAME using a ballpoint pen or
similar object.
If you do not complete each of the following steps within 30
seconds, the renaming mode will be automatically canceled.
In this case, start over from 2.
Notes
SELECT
DTV
DVR/VCR 2
VCR 1
DVD
CBL/SAT
MD/TAPE
CD-R
PHONO
TUNER CD
MULTI CH IN
SLEEP
AUDIO SEL
POWER
POWER
POWER
STANDBY
NET/USB
AV
TV
V
-
AUX/DOCK
(U.S.A. model)
Other remote control
LEARN
Changing source names in the
display window
Note
V
-
AUX/DOCK
DTV
DVR/VCR 2
VCR 1
DVD
CBL/SAT
MD/TAPE
CD-R
PHONO
TUNER CD
MULTI CH IN
NET/USB
TV
SOURCE
AMP
TV
SOURCE
AMP
(U.S.A. model)
or
RENAME