Filter
Top Products
73
English
OTHER FEATURES
6
■ Checking the firmware version
(Firm. Version)
Software that is called “firmware” is built into this unit. This
firmware controls the operation. The following steps describe the
firmware version check procedures.
1. Press MENU while this unit is in the stop mode.
The display changes for the menu item selection.
2. Rotate the MULTI JOG knob (press +/–, H or G on the
remote control) to select “Sys. Utility”.
3. Press the MULTI JOG knob (ENTER on the remote
control) to display “Firm. Version”.
4. Press the MULTI JOG knob (ENTER on the remote
control) again to display the version of the firmware.
Rotating the MULTI JOG knob (pressing +/–, H or G on the
remote control) changes the display as follows.
5. Press a or MENU to exit.
The unit returns to the stop mode.
SYSTEM UTILITY
Sys. Utility
L
R
dB –30 –10 –6 –2 0
Firm. Version
L
R
dB –30 –10 –6 –2 0
System firmware version
V1.0.00 Jun 2
L
R
dB –30 –10 –6 –2 0
CDR drive firmware version
CDRW 7.06
L
R
dB –30 –10 –6 –2 0
Model of HDD
ABCDEFGHIJKLM
L
R
dB –30 –10 –6 –2 0
■ Initializing settings (Initialize)
You can initialize the settings that have been changed. The OPC
data stored in this unit is also initialized.
1. Carry out steps 1 to 3 in “Checking the firmware
version (Firm. Version)” (at left).
The display changes for the system utility item selection.
2. Rotate the MULTI JOG knob (press +/–, H or G on the
remote control) to select “Initialize”.
3. Press the MULTI JOG knob (ENTER on the remote
control) to display “Initialize ?”.
Press a to cancel the initialization process.
4. Press COMPLETE.
The unit restarts with the initial settings.
Initialize
L
R
dB –30 –10 –6 –2 0
Initialize ?
L
R
dB –30 –10 –6 –2 0
107_HD1500(E)71-75.p65 3/20/05, 12:4373