Teac AG-15D Home Theater System User Manual


 
ENGLISH
Remote Control Unit 4
38
Macro Function
This function enables you to program up to 10 sequential
operations into a single button.
You can store up to three sequences (macros) into the M1,
M2 and M3 buttons.
Press and hold down both the ENTER button and one of
three numeric buttons (1, 2 or 3) corresponding to the
number of MACRO button (M1, M2 or M3) for more
than 1 second.
For example, if you want to program a macro into the M1
button, press the ENTER button and “1”.
The LED will flicker once.
Press the operation buttons you want to program in
order.
Note:
You should press the corresponding REMOTE SELECT buttons
before pressing each operation button.
Example:
You want to play a DVD on the DVD player connected to
VIDEO 2 jacks of this receiver. You can set a macro to turn on
all the components (Receiver, DVD player and TV) and start
playing the movie all in one press of a button. Once you have
put your remote into the learning mode as shown in the step
above, enter the following:
1. Press the RECEIVER button to control the receiver.
2. Press the STANDBY/ON button to turn the receiver on.
3. Press the RECEIVER button.
4. Press the VIDEO 2 button to select the input source.
5. Press the TV button to control the TV.
6. Press the STANDBY/ON button to turn the TV on.
7. Press the DVD button to control the DVD player.
8. Press the STANDBY/ON button to turn the DVD player on.
9. Press the DVD button.
10. Press the PLAY button to start playback.
Press the ENTER button to store the macro.
If the macro is programmed successfully, the LED will flicker
twice.
<
If you program a new macro into a MACRO button, the
previously programmed macro will be overwritten.
To delete a macro program:
Perform steps and , but ignore step .
231
3
2
1
1
3
2