Filter
Top Products
ENGLISH
Troubleshooting 2
106
Cannot view the on-screen display as it rolls rapidly.
e
The color system of the receiver does not match your TV.
Connect a PAL TV.
Cannot listen to any station, or signal is too weak.
e
Make sure the antenna is properly connected.
e
Tune in the station properly.
e
If a TV is near the unit, turn it off.
e
Install the antenna again after relocating it to a better
reception position.
e
An external antenna may be required.
Though the broadcast is stereo, it sounds monaural.
e
Press the FM MODE button.
Remote control doesn’t work.
e
Select the component to be controlled by pressing the
REMOTE SELECT buttons (RECEIVER, CD, AUX, TV, VCR,
DVD, CABLE, SAT) of the remote control unit. (Even when
the REMOTE SELECT buttons are pressed without pointing
at the main unit, the selection of the remote control unit will
be changed.)
If you want to control the receiver, first press the RECEIVER
button, and then press buttons to operate.
e
Press the POWER switch of the main unit to turn it standby.
e
If the batteries are dead, change the batteries.
e
Use remote control unit within the range (5m) and point at
the front panel.
e
Clear obstacles between the remote control unit and the
main unit.
e
If a strong light is near the unit, turn it off.
If normal operation cannot be recovered, unplug the
power cord from the outlet and plug it again.
Maintenance
If the surface of the unit gets dirty, wipe with a soft cloth or
use diluted mild liquid soap. Be sure to remove any excess
completely. Do not use thinner, benzine or alcohol as they
may damage the surface of the unit.