Filter
Top Products
TASCAM MD-CD1
Owner’s Manual
9
2 – Remote control unit
Some notes and precautions
• When the remote control will not be used for an
extended period of time, please remove the batter-
ies to prevent the possibility of battery acid leakage
which could damage the unit. Should leakage
occur, remove and discard the batteries, and wipe
the battery case thoroughly with a cloth. Avoid get
-
ting the battery liquid on the skin. After cleaning,
replace with new batteries.
• The remote control functions by using an infrared
light signal. When using the unit to control the
MD-CD1, other devices that are turned on could be
operated by its signal.
• If the range of remote operation becomes smaller,
or commands do not always function properly, the
batteries have become weak and should be
replaced. Always replace both batteries with new
batteries of the same type.
• Point the remote control to the remote sensor on
the main unit.
Do not obstruct the path between the remote con-
trol and the remote sensor.
Batteries
If batteries are used improperly, or if leakage or
breakage occurs, the unit will not function. Please
observe the cautions indicated on the batteries and
their packaging to ensure proper usage.
• Confirm + and – polarity and follow the indications
when inserting new batteries into the remote con-
trol.
• Do not use old and new batteries together.
•Even if the battery is the same size, the voltage
may differ. Do not use batteries of different specifi-
cations together.
• Do not attempt to recharge batteries that are non-
rechargeable.
• Do not open or disassemble batteries, throw them
into a fire or put them in water.
Inserting batteries
1. Open the lid.
2. Confirm +/- polarity, and insert two AA bat-
teries.
3. Close the lid.
7m
2ReMD-CD1.fm 9ページ ２００４年１１月５日 金曜日 午前７時３５分