Filter
Top Products
F6 Remote Control Handset
Replacing the batteries:
To open the battery compartment cover release the latch
by pressing it in and raising the end. Fit new dry batteries
of the LR 03 (MICRO) type, taking care to position them
with correct polarity as shown by the engraved markings.
Please remember that all the cells must be replaced at
the same time.
If you have already switched the remote control
to Address 2, you will need to repeat the
procedure after changing the batteries (see
Chapter 'Changing the remote control
address').
Disposal of exhausted batteries:
Used batteries must not be discarded in the
household waste! In accordance with the
Battery Disposal Regulation (BattVO) they must
be returned to the retailer (shop) or to your local
toxic waste collection point, where they will be
destroyed or recycled safely. All local authorities
are now obliged to provide such collection
points, and / or vehicles for collecting exhausted
batteries.
Switching the remote control address
In rare cases you may find that other remote-controlled
equipment in your household uses the same infra-red
control codes as the K1 AV. This problem manifests itself
in the wrong piece of equipment responding to
commands, and carrying out unwanted actions. The
K1 AV can be switched to a different remote control
address to eliminate such problems.
K1 AV - setting the remote control address:
Switch the machine on and - while the loudspeaker
symbols are still flashing - hold the button
pressed in until a running script appears on the integral
screen.
When the running script stops, immediately hold the
button pressed in for about two seconds.
This action switches the machine to the alternative
remote control address, and displays the new address
‘RC-ADR 1’ or ‘RC-ADR 2’ on the screen.
F6 - setting the remote control address:
Now you have to set the address of the F6 remote control
handset to match that of the K1 AV:
Hold the v button and the numeric button ó
pressed in simultaneously. After about ten seconds the
LED on the handset will flash. Now press the numeric
button ñ or ò, as required.
Pressing the numeric button ñ sets the remote
control handset to the standard remote control address
(RC-ADR 1), while the numeric button ò sets the
alternative address (RC-ADR 2). The LED now goes out
to indicate that the change has taken place.
:
IMPORTANT
The K1 AV and F6 must always be set to the
same address!
45