Filter
Top Products
85
GB
D:\NORM'S JOB\SONY HA\SO0126\STR-DN1020\4282218111_GB Web\GB05ENJ_STR-
DN1020-CEL.fm
masterpage: Right
STR-DN1020
4-282-218-11(1)
Other Operations
Using Auto Volume
function
You can adjust the volume automatically
depending on the input signal or content from
the connected equipment (ADVANCED
AUTO VOLUME function).
This function is useful, for example, when the
sound of a commercial is louder than the TV
programs.
Press AMP, then press AUTO VOL.
The auto volume function is set to on and off
as you press AUTO VOL.
Notes
• Be sure to reduce the volume level before you turn
off this function.
• As this function is available only when Dolby
Digital, DTS or Linear PCM signals are input, the
sound may suddenly increase when you switch to
other formats.
• This function does not work in the following cases.
– Linear PCM signals with a sampling frequency
of more than 48 kHz are being received.
– Dolby Digital Plus, Dolby TrueHD, DTS 96/24,
DTS-HD Master Audio, or DTS-HD High
Resolution Audio signals are being received.
Switching between
digital and analog audio
(INPUT MODE)
When you connect equipment to both digital
and analog audio input jacks on the receiver,
you can fix the audio input mode to either of
them, or switch from one to the other,
depending on the type of material you intend
to watch.
1 Turn INPUT SELECTOR on the
receiver to select the input.
You can also use the input buttons on the
remote control.
2 Press INPUT MODE repeatedly
on the receiver to select the
audio input mode.
The selected audio input mode appears on
the display panel.
• AUTO: Gives priority to digital audio
signals. If there are more than one
digital connection, HDMI audio signals
have priority.
If there are no digital audio signals,
analog audio signals are selected. When
TV input is selected, priority is given to
the Audio Return Channel (ARC)
signals. If your TV is not compatible
with the Audio Return Channel (ARC)
function, the digital optical audio
signals are selected.
• COAX: Specifies the digital audio
signals input to the DIGITAL
COAXIAL jack.
• OPT: Specifies the digital audio signals
input to the DIGITAL OPTICAL jack.
• ANALOG: Specifies the analog audio
signals input to the AUDIO IN (L/R)
jacks.
Other Operations
AMP
AUTO
VOL
continued