Filter
Top Products
109
GB
D:\NORM'S JOB\SONY HA\SO0126\STR-DN1020\4282218111_GB Web\GB06REM_STR-
DN1020-CEL.fm
masterpage: Right
STR-DN1020
4-282-218-11(1)
Using the Remote Control
Programming the remote
control
You can customize the remote control to
match the equipment connected to your
receiver. You can even program the remote
control to operate non-Sony equipment and
also Sony equipment that the remote control is
normally unable to control.
Before you begin, note that:
– You cannot change the settings of TUNER,
USB, HOME NETWORK and MUSIC
SERVICES input buttons.
– The remote control can only control
equipment that accept infrared wireless
control signals.
1 Press and hold RM SET UP,
then press AV ?/1.
The RM SET UP indicator flashes slowly.
2 Press the input button of the
equipment you want to
program.
For example, if you are going to program
a VCR connected to VIDEO 1 jacks,
press VIDEO 1.
The RM SET UP and SHIFT indicator
light up.
3 Press the numeric buttons to
enter the numeric code.
If more than one code exists, try to enter
either one which corresponds to the
equipment including TV.
Use the tables on page 110–113 to find
the numeric code(s) corresponding to the
equipment.
Note
Only the codes in the 500’s are valid for the TV
button.
4 Press ENT/MEM.
Once the numeric code has been verified,
the RM SET UP indicator slowly flashes
twice and the remote control
automatically exits the programming
mode.
5 Repeat steps 1 to 4 to program
other equipment.
Note
The RM SET UP indicator turns off while a numeric
button is pressed.
To cancel programming
Press RM SET UP during any step. The
remote control automatically exits the
programming mode.
To activate the input after
programming
Press the programmed button to activate the
input you want.
If programming is
unsuccessful, check the
following:
• If the RM SET UP indicator does not light
up in step 1, the batteries are weak. Replace
both batteries.
• If the RM SET UP indicator flashes 5 times
in quick succession while entering the
numeric code, an error has occurred.
Start again from step 1.
Using the Remote Control
RM
SET UP
TV
SHIFT
Input
buttons
AV ?/1
Numeric
buttons
ENT/MEM