Filter
Top Products
123
GB
D:\NORM'S JOB\SONY HA\SO0126\STR-DN1020\4282218111_GB Web\GB07ADD_STR-
DN1020-CEL.fm
masterpage: Right
STR-DN1020
4-282-218-11(1)
Additional
Information
The receiver cannot be turned on
automatically when accessed by
devices on the network.
• The receiver itself does not support the
Wake-on-LAN standard. Therefore the
receiver cannot be turned on by Wake-on-
LAN when “Network Standby” is set to
“Off”. Set “Network Standby” to “On” so
that the receiver can respond to operations
by other devices via a network (page 101).
Devices on the network cannot turn on
the receiver.
• The receiver cannot be turned on with a
Wake-on-LAN start up operated by other
devices on a network.
The receiver cannot play the track that
is currently being played by the PARTY
host.
• The PARTY host is playing a track of an
audio format that cannot be played on the
receiver.
• It may take a while before the playback
sound is output.
The receiver joins an unintended
PARTY.
• If more than one PARTY has been started
when the receiver joins, the receiver may
not be able to join the PARTY you want.
Close the other PARTY, and then join the
PARTY you want.
You cannot connect the receiver to a
service.
• Make sure that the router is turned on.
• Check the network status. See “To check
the network information” (page 99), then
select “Connection” in step 2. If “No
Connection” appears, set up the network
connection again (page 69).
• If your contract with your Internet
provider limits Internet connection to one
device at a time, this device will not be
able to access the Internet when another
device is already connected. Consult your
carrier or service provider.
The remote control does not function.
• Point the remote control at the remote
control sensor on the receiver.
• Remove any obstacles in the path between
the remote control and the receiver.
• Replace all the batteries in the remote
control with new ones, if they are weak.
• Make sure you select the correct input on
the remote control.
• When you operate a programmed non-
Sony equipment, the remote control may
not function properly depending on the
model and the manufacturer of the
equipment.
The Control for HDMI function does not
work.
• Check the HDMI connection (page 23,
24).
• Make sure “Ctrl for HDMI” is set to “ON”
in HDMI Settings menu.
• Make sure the connected equipment is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on
the connected equipment. Refer to the
operating instructions of the connected
equipment.
• When “Ctrl for HDMI” is set to “OFF”,
the “BRAVIA” Sync does not work
properly, even if the equipment is
connected to the HDMI IN jack.
Music Services
Remote control
Other
continuedcontinued