Filter
Top Products
Basic Operations
Basic Operations
9
Rear of the disc
Do not disconnect the deck from the power source immediately after
recording
If you do, recorded material may not be saved to the MD. To save the
material, after recording, press § EJECT to take out the MD or change the
deck to standby by pressing 1/u. “TOC Writing” will flash at this time.
After “TOC Writing” goes out, you can pull out the AC power cord.
To protect an MD against accidental erasure
To make it impossible to record on an MD, slide the tab in the direction of
arrow, opening the slot. To allow recording, close the slot.
Notes
• You cannot record over existing
material during CD Synchro-
Recording. The deck
automatically starts recording
from the end of the existing
material.
• Make sure that the remaining
recordable time on the MD is
longer than the playing time of
the CD, especially if you want to
record all the tracks on the CD.
• You cannot pause recording
during CD Synchro-Recording.
• The recording level specified in
the Setup Menu (page 20) is not
applied during CD Synchro-
Recording. The initial reference
level (0.0 dB) is used instead.
When “TOC Writing” flashes in
the display
The deck is currently updating the
Table Of Contents (TOC). Do not
move the deck or pull out the AC
power cord. Changes to an MD
made through recording are saved
only when you update the TOC by
ejecting the MD or changing the
deck to standby by pressing
the 1/u switch.
Slide the tab in the
direction of arrow
Record-protect tab