Filter
Top Products
Playing CDs and MDs
13
Adjusting the Output Level
You can adjust the level of the playback signal output
from the LINE (ANALOG) OUT and PHONES jacks.
MENU/NO AMS
1/u
§§
0)
≠±≠±
r
pP
·
0)
pP
·
= +
0 )
r
P
·
p
1 / u
><
+
–
^
^
LEVEL
+
/
–
1 While the deck is stopped, playing, or pausing,
press MENU/NO twice to display “Setup Menu.”
2 Turn AMS to select “Aout”, then press AMS.
3 Turn AMS to change the output level within a
range of 0.0 dB to –20.2 dB, then press AMS.
4 Press MENU/NO.
z You can also change the output level using the
remote Z
During playback, press LEVEL +/– repeatedly. Note
that the level cannot go above 0 dB or lower than –20.2
dB.
Note
The output level setting returns to the initial value (0.0 dB)
when you turn off the deck or disconnect the AC power
cord.
Playing Tracks Repeatedly
(Repeat Play) Z
You can play tracks repeatedly in any play mode.
= +
0 )
r
P
·
p
1 / u
><
+
–
^
^
SELECT
REPEAT
1 Set SELECT to CD or MD.
2 Press REPEAT repeatedly until “REPEAT”
appears in the display.
The deck repeats the tracks as follows:
When the disc is played in The deck repeats
Normal play (pages 6 and 7) All the tracks
Shuffle Play (page 14) All the tracks in random
order
Program Play (page 14) The same program
To stop Repeat Play
Press p.
To cancel Repeat Play
Press REPEAT repeatedly until “REPEAT” disappears.
Repeating the current track only
While the track you want to repeat is playing in
normal, Shuffle or Program Play, press REPEAT
repeatedly until “REPEAT 1” appears in the display.
If you select “REPEAT 1” while the deck is stopped,
the deck repeats the next track that you locate to play.