Filter
Top Products
Additional Information
37
“TOC Reading” appears for a long time
If the inserted recordable MD is brand new, “TOC Reading”
appears in the display longer than for MDs that have been
used.
Limitations when recording over an existing track
• The correct remaining recording time may not be
displayed.
• You may find it impossible to record over a track if that
track has been recorded over several times already. If this
happens, erase the track using the Tr Erase Function (see
pages 26 and 27).
• The remaining recording time may be shortened out of
proportion to the total recorded time.
• Recording over a track to eliminate noise is not
recommended since this may shorten the duration of the
track.
• You may find it impossible to label a track while recording
over it.
The correct recorded/playing time may not be displayed
during playback of monaural-format MDs.
Troubleshooting
If you experience any of the following difficulties while
using the deck, use this troubleshooting guide to help
you remedy the problem.
CD player section
The player does not start playing.
/Insert a CD.
/Place the CD properly.
/Clean the CD.
/Moisture condensation has formed inside the deck.
Take the CD out and leave the deck turned on for
about an hour until the moisture evaporates.
MD deck section
The deck does not operate or operates poorly.
/The MD may be damaged (“Disc Error!!” appears).
Take the MD out and insert it again.
If “Disc Error!!” remains, replace the MD.
The deck does not play back.
/Moisture has formed inside the deck. Take the MD out
and leave the deck in a warm place for several hours
until the moisture evaporates.
/Press 1/u to turn the deck on.
/Slide the MD into the disc slot with the label side up
and the arrow pointing towards the opening.
/Replace the disc with one that has been recorded.
The deck does not record.
/The MD is record-protected (“Protected” appears and
“C11” flashes).
Close the record-protect slot (see page 9).
/Make connections properly to the sound source.
/The sound source is not connected to the selected input
connector. Select the correct input connector using
INPUT.
/The recording level is not adjusted properly. Adjust
the recording level properly (see pages 20 and 21).
/A premastered MD is inserted. Replace it with a
recordable MD.
/There is not enough time left on the MD. Replace it
with another recordable MD with fewer recorded
tracks, or erase unnecessary tracks.
/There has been a power failure or the AC power cord
has been disconnected during recording. Data
recorded to that point may be lost. Repeat the
recording procedure.
The sound has a lot of static.
/Strong magnetism from a television or a similar device
is interfering with operations. Move the deck away
from the source of strong magnetism.
The three-digit display appears.
/The Self-Diagnosis Function is on.
Check the table on page 43.
Others
No sound is output.
/Make the connections properly.
/Operate the amplifier properly.
/When using the headphones, turn PHONE LEVEL to
turn up the output level.
The remote does not operate the deck.
/Make sure that there is no obstacles between the deck
and the remote.
/Point the remote at the remote sensor on the deck.
/Replace the batteries in the remote.
After you’ve attempted the prescribed
remedies
If the deck still does not operate properly, or if other
problems not described above occur, turn off the deck,
then reinsert the plug into the power outlet.
If the problem persists, reset the system as follows:
1 Turn off the deck and unplug the AC power cord.
2 Reinsert the plug into the power outlet while
pressing down 1/u.
Should any problem persist even after resetting the
system, consult your nearest Sony dealer.