Filter
Top Products
Editing Recorded MDs
32
5
Press AMS or YES.
A flashing cursor appears in the display.
18 68m40s
6 Press TIME/CHAR to select the character type as
follows:
To select Press TIME/CHAR repeatedly until
Uppercase letters “A” appears in the display
Lowercase letters “a” appears in the display
Numbers “0” appears in the display
Symbols “!” appears in the display
A
18 68m40s
7 Turn AMS to select the character.
The selected character flashes.
Letters, numbers, symbols, and a space appear in
sequential order as you turn AMS.
You can use the following symbols in titles:
! ” # $ % & ’ ( )
+ , – . / : ; < = > ? @ _ `
D
18 68m40s
You can press TIME/CHAR to change the
character type at any time during Step 7 (see Step 6
above).
8 Press AMS to enter the selected character.
The selected character stops flashing and the
cursor flashes waiting for the input of the next
character.
D
18 68m40s
9 Repeat Steps 7 and 8 until you have entered the
entire title.
If you entered the wrong character
Press 0 or ) until the character to be corrected
starts flashing, and repeat Steps 7 and 8 to enter
the correct character.
To erase a character
Press 0 or ) until the character to be erased
starts flashing, then press CLEAR.
To enter a space*
Press AMS while the cursor is flashing.
* You cannot select a space for the first character of the
title.
10 Press YES.
This completes the labeling procedure and the title
appears in the display.
To cancel labeling
Press MENU/NO or p.
Note
You cannot label a track or an MD while you are recording
over an existing track.