Filter
Top Products
71
On the remote control
1 While the recorder is stopped,
playing, or play-paused, press
DISPLAY for 2 seconds or more.
2 Turn the control towards . or
N> until “M-TIMER” flashes in
the display, and then press
x.
3 Turn the control towards . or
N> until “ON” flashes in the
display, and then press
x.
, lights up in the display and the
alarm sound can be selected.
4 Turn the control towards . or
N> to select the alarm sound.
The following sounds can be selected.
5 Press x.
The alarm sound is set.
6 Turn the control towards . or
N> to select the elapsed time.
One rotation of the control changes
the elapsed time setting (TIME :) by 1
minute, within a range of 1 to 99
minutes. To change the time quickly,
turn and hold the control towards
. or N>.
7 Press x.
The alarm is set.
The time remaining until the alarm is
shown in the display while the
recorder is stopped or play-paused.
To check the time remaining
on the alarm while playing
Follow steps 1 to 3 again. The remaining
time and the selected sound appear in the
display.
To cancel setting the alarm
Press DISPLAY for 2 seconds or more.
To cancel Melody Timer
Select “OFF” in step 3 and then press the
jog dial on the recorder or
x on the
remote control.
To stop the alarm
Press any button. Note that the button’s
original function will not activate at this
time.
z
• If you end the procedure after step 3, the
previous alarm setting is automatically used.
• After sounding for one minute, the alarm will
automatically stop and the alarm setting will
be canceled. If the alarm sounds during stop
mode, then the power will automatically turn
off 10 seconds after the alarm stops. If the
alarm stops while an MD is playing, the
playback will continue uninterrupted.
Display Alarm sound
TIMER 1 Classical music 1
TIMER 2 Classical music 2
TIMER 3 Beeps
DISPLAY
Control
x