Filter
Top Products
55
Editing recorded tracks
You can edit your recordings by adding/
erasing track marks or labeling tracks and
MDs. Premastered MDs cannot be edited.
Notes on editing
• Do not move or jog the recorder while “TOC
Edit”* is flashing in the display.
• You cannot edit tracks on an MD that is
record-protected. Before editing tracks, close
the tab on the side of the MD (page 77).
• If you perform an editing operation while
playing, be sure not to turn the power off until
“TOC Edit” disappears in the display.
• The lid does not open until “TOC Edit”
disappears in the display after editing.
• When the group mode is on, editing can be
performed only for the tracks registered into
the selected group.
∗ TOC = Table of Contents
Labeling recordings
You can name tracks, discs and groups
using the recorder’s character palette.
You can name tracks or groups during
playback, discs during stop, and all during
recording. Each name can be as long as
200 letters.
Each disc can hold up to 1,700
alphanumeric letters during playback or
stop.
Available characters
• Capital and small letters of the English
alphabet
• Numbers 0 to 9
• ! " # $ % & ( ) * . ; < = > ?
@ _ ` + – ' , / : _ (space)
Notes
• “NAME FULL” appears when you try to enter
more than 1,700 characters on a disc. Enter a
shorter name for the track, group, or disc, or
set the “LP Stamp” setting to “Stamp OFF”
when recording in MDLP mode so that “LP:”
is not be added at the beginning of the track
name (page 29).
• When labeling a disc which has been recorded
using the group function, be sure to turn the
group function on to avoid misoverwrite the
group management information.
• If you enter the symbol “//” between the
characters in disc names such as “abc//def”,
you may be unable to use the group function.
About the character palette
The character palette appears in the
display when the recorder is ready to
accept character input.
The character palette has the following
configulation.
The character palette will appear in the
display as shown below.
On the recorder
Labeling a disc during stop
To label a disc that contains group
settings, you must turn the group mode on
before doing the labeling procedure.
1 Insert a disc.
ABCDEFGHI
abcdefghi
The cursor flashes.
VOL +/–
X/x/./>/N
GROUP/
CANCEL
Jog dial
END SEARCH
continued