Sony CMT-WS2D Stereo System User Manual


 
58
GB
Should you encounter a problem with your
system, do the following:
1 Make sure the power cord and speaker
cords are correctly and firmly connected.
2 Find your problem in the troubleshooting
checklist below and take the indicated
corrective action.
If the problem persists after doing all of the
above, consult your nearest Sony dealer.
General
The display starts flashing as soon as you
plug in the power cord even though you have
not turned on the system (see step 5 of
“Hooking up the system” (page 8)).
Press DISPLAY while the system is off. The
demonstration disappears.
“– –:– –” appears in the display.
A power interruption has occurred. Set the clock
(page 11) and timer settings (page 48) again.
The clock setting/radio presetting/timer is
canceled.
Redo the following:
– “Setting the clock” (page 11)
– “Presetting radio stations” (page 42)
– “Falling asleep to music” (page 48) and
“Waking up to music” (page 48)
There is no sound.
Press VOLUME + or turn VOLUME control on
the unit clockwise.
Make sure the headphones are not connected.
Check the speaker connections (page 8).
The system is in pause mode or in slow-motion
play mode. Press H to return to normal play
mode.
Fast forward or fast reverse is performed. Press
H to return to normal play mode.
There is severe hum or noise.
Move the system away from the source of noise.
Connect the system to a different wall outlet.
Install a noise filter (commercially available) to
the power cord.
The timer cannot be set.
Set the clock again (page 11).
The timer does not function.
Check the timer setting and set the correct time
(page 48).
Cancel the Sleep Timer function (page 48).
The remote does not function.
Remove the obstacle.
Move the remote closer to the system.
Point the remote at the system’s sensor.
Replace the batteries (R6/size AA).
Locate the system away from the fluorescent light.
Troubleshooting
Problems and remedies
When the ?/1 indicator flashes
Immediately unplug the power cord and
check the following items.
Are the + and – speaker cords short-
circuited?
Are you using the supplied speakers?
Is anything blocking the ventilation holes
on the rear of the system?
Check all the above items and fix any
problems found. After ?/1 indicator stops
flashing, reconnect the power cord and turn
on the system. If the indicator still flashes, or
if the cause of the problem cannot be found
even after checking all the above items,
consult your nearest Sony dealer.