Filter
Top Products
PRESETTING STATIONS
–-~–=z
2
.............J
MONO
TUNER
BAND
SHIFT
Press the lWNER/BAND button repeatedly to
select the desired band, FM or AM.
To select a bared with the remote control
Press the BANID button while pressing the SHIFT button.
Press the H DOWN or W UP button to select
a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed for 2 seconds.
During FM stereo reception, 1[1~11) is displayed.
To
search for a station quickly (Auto Search)
Keep the h+ DC)WN or W UP button pressed until the tuner
starts searching for a station. After tuning in to a station, the
search stops.
To stop the Auto Search manually, press the 1<< DOWN or PM
LIP button.
● The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the MONO “TUNER button while pressing the SHIFT button
on the remote cointrol to display “MONO”.
Noise is reduced, although reception is monaural.
MONO
10 restore stereo reception, press these buttons again so that
“MONO disappears.
To
change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
With the unit turned on, press the POWER button while pressing
the TUNER/BANll button.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations (see
“PRESETTING STATIONS”) are cleared. The preset stations
have to be set again.
The unit can store a total of 32 preset stations. When a station
is stored, a preset number is assigned to the station. Use the
preset number to tune into a preset station directly.
*PRESET
1
2
■CLEAR
1
0-9,+1 o
BAND
SHIFT
1
2
3
Press the TUNER/BAND button to select a band,
and press the l++ DOWN or M UP button to
tune in to a station.
Press the II SET button to store the station.
A station is assigned a preset number, beginning from 1 in
consecutive order for each band.
Frequ?ncy
Preset number
Repeat steps 1 and 2.
ImaE3
Each band can only store a maximum of 20 preset stations.
However, the next station will not be stored if a total of 32 preset
stations have already been stored for all the bands.
PRESET NUMBER TUNING
Use the remote control to select the preset number directly.
1
Press the BAND buttoln while pressing the SHIFT
button to select a band.
2 Press the numeric buttons to select a preset
number.
Example:
To select preset number 20, press the +10, +10 and Obuttons.
To select preset number 15, press the +10 and 5 buttons.
Selecting a preset number on the main unit
Press the TUNER/BAND button to select a band. Then, press
the E PRESET button repeatedly.
Each time the button is pressed, the next higher number is
selected.
To clear a preset station
Select the preset number of the station to be cleared, Then, press
the M CLEAR button, and press the II SET button within 4
seconds.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
ENGLISH 8