Filter
Top Products
SETTING THE TIMER
3
1,2
2,4
B
“7”--J--”l-j:-------!-:. M
/
1
2,4
1,2
6
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly. (See page 6.)
1
2
3
Press the TIMER button once while pressing the
SHIFT button on the remote control to display
0, and press the I I SET button within 4 seconds.
O k
displayed, and the hour flashes.
m
If you do not press the El SET button within 4 seconds,
another operation may start,
Designate the hour of the timer-on time by
pressing the H DOWN or M UP button, and
the II SET button. Repeat to designate the minute
of the timer-on time.
After you designate the timer-on time, one of the source
names flashes on the display for 4 seconds.
Within 4 seconds, press one of the function
buttons to select a source.
The selected source name flashes for 4 seconds.
● If this step is not completed within 4 seconds, repeat from
step 1.
● If the TUNER/BAND button is pressed, the band cannot be
selected in this step.
4 Within 4 seconds, select the duration for the
timer-activated period with the M DOWN or
➤Fl
UP button.
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
● If this step is not completed within 4 seconds, repeat from
step 1.
5 Prepare the source.
To listen to CD, load the disc(s) to be played.
To listen to tape playback, insert a tape into the deck.
To listen to a radio broadcast or record it, tune in to a station.
When recording from the tuner, insert the tape to be recorded
on into deck 1.
6 Press the POWER button to turn the unit off after
adjusting the volume and tone.
@
remains on the display after the power is turned off (timer
standby mode).
7 Get ready for the TAPE function or the timer
recording.
To listen to the tape, press the - button.
To record the source, press the ● button on deck 1.
When the timer-on time is reached, the unit turns on and begins
play or record with the selected source.
The timer recording period and tape length
When the length of the tape to be recorded is shorter than the
timer recording period, the
● button on deck 1 is released before
the timer is off.
When the tape length is longer than the timer recording period,
the
● button is not released. If the ● is not released for a long
time, the tape in the deck may be damaged. Press the WA
button to release the
● button.
To cancel the timer standby mode temporarily
While pressing the SHIFT button, press the TIMER button so
that @ goes out in the display.
To restore the timer standby mode, press these buttons again to
display 0.
If using the unit after setting the timer
After setting the timer, you can use the unit. After using the unit,
check whether the contents in step 5 are set as you wish, turn
off the power and set step 7 if necessary.
To change the specified time and function
Repeat all the steps again.
To check the specified contents
While pressing the SHIFT button, press the TIMER button. The
timer-On time, the selected source name and timer-activated
period are displayed alternately for 4 seconds.
m
● Timer playback and timer recording will not begin unless the
power is turned off.
● Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
17 ENGLISH