Filter
Top Products
Additional Information
123
US
Picture
Symptom Remedy
There is no picture. • The video connecting cords are not connected securely.
•The video connecting cords are damaged.
•The unit is not connected to the correct TV input jack (page 48).
•The video input on the TV is not set so that you can view pictures from the
system.
• Check the output method on your system (page 48).
•Re-connect the connecting cord securely.
•The unit is connected to an input device that is not HDCP (High-bandwidth
Digital Content Protection) compliant (“HDMI” on the front panel does not
light up) (page 48).
•When playing a double-layer DVD, the video and audio may be momentarily
interrupted at the point where the layers switch.
No picture appears when the
video output resolution selected
in [Output Video Format] is
incorrect.
• Press and hold H and A on the unit for more than 5 seconds to reset the video
output resolution to the lowest resolution.
Video signals are not output
from the jacks, other than from
the HDMI OUT jack, when
connecting the HDMI OUT jack
and other video output jacks at
the same time.
•Set [Output Video Format] to [Component Video] in [Video Settings]
(page 109).
The dark area of the picture is too
dark/the bright area is too bright
or unnatural.
•Set [Picture Quality Mode] to [Standard] (default) (page 72).
The picture is not output
correctly.
• Check the [Output Video Format] settings in [Video Settings] (page 109).
Picture noise appears. • The disc is dirty or flawed.
•If the picture output from your system goes through your VCR to get to your
TV, the copy-protection signal applied to some BD/DVD programs could affect
picture quality. If you still experience problems even when you connect your
unit directly to your TV, try connecting your unit to the other input jacks
(page 48).
Even though you set the aspect
ratio in [TV Type] of [Video
Settings], the picture does not fill
the TV screen.
•The aspect ratio on the disc is fixed.
Color irregularity occurs on the
TV screen.
• If the speakers are used with a CRT-based TV or projector, install the speakers
at least 0.3 meters (1.0 ft) from the TV set.
• If the color irregularity persists, turn off the TV set once, then turn it on after 15
to 30 minutes.
•If howling occurs, reposition the speakers farther away from the TV set.
•Make sure that no magnetic object (magnetic latch on a TV stand, health care
device, toy, etc.) is placed near the speakers.