Filter
Top Products
External Audio Device
93
US
xAfter pairing
Sound transmission is established between the
paired unit and S-AIR sub unit(s) only.
To perform pairing
1 Place the S-AIR sub unit that you want
to pair near the unit.
Note
•Remove headphones from the surround
amplifier (if connected).
2 Match the IDs of the unit and the S-AIR
sub unit.
• To set the ID of the unit, see “To set the ID
of the unit” (page 89).
• To set the ID of the surround amplifier,
see “To set the ID of the surround
amplifier” (page 90).
• To set the ID of the S-AIR receiver, refer
to the operating instructions of the S-AIR
receiver.
3 Press HOME.
The home menu appears on the TV screen.
4 Press C/c to select [Setup].
5 Press X/x to select [System Settings],
then press .
6 Press X/x to select [S-AIR Pairing],
then press .
The confirmation display appears.
7 Press C/c to select [OK], then press
.
The unit starts pairing.
To not perform pairing, select [Cancel].
8 Start pairing of the S-AIR sub unit.
xFor the surround amplifier
Press POWER on the surround amplifier to
turn on the surround amplifier and press
PAIRING on the rear panel of the surround
amplifier.
The PAIRING indicator of the surround
amplifier flashes red when pairing starts.
When sound transmission is established,
the PAIRING indicator of the surround
amplifier turns red and the confirmation
display appears.
Ti
p
• To press PAIRING on the rear panel of the
surround amplifier, a slim instrument, such as a
paper clip, can be used.
xFor the S-AIR receiver
Refer to the operating instructions of the
S-AIR receiver.
When sound transmission is established,
the confirmation display appears.
Note
• Perform the pairing within several minutes after
Step 8. If you do not, the pairing is canceled
automatically and the confirmation display
appears. To perform pairing, select [OK]. To
return to the previous display, select [Cancel].
9 Press C/c to select the next operation.
xTo finish pairing
Select [Finish], then press .
xTo perform pairing of another S-AIR
sub unit
Select [Continue], then press .
Note
• If you perform the pairing operation between the unit
and another S-AIR sub unit (page 92), sound
transmission established by ID is canceled.
• When you perform pairing, [(Pairing)] appears beside
ID on the display for selecting ID.
HDMI S-AIR
This unit
ID A
S-AIR sub unit
ID A ID A
S-AIR sub unit
Your room
Neighbor
Pairing
No transmission