Filter
Top Products
17
7 REMOTE CONTROL
The remote control transmits commands to the system by
infrared signals.
There are three infrared sensors, one at the front of the Projector,
one at the rear of the Projector and one on the front panel of
the DigiOptic™ Image Processor.
It is possible to control the projector by pointing the remote
control at the screen; the sensor at the front of the projector will
pick up the reflected infrared commands. (Fig. 16).
Avoid placing obstructions between the remote control and the
infrared sensor at the front of the projector; this will impair the
remote control performance.
Fig. 17
6 KEYBOARD PAD
Eight push buttons, at the rear of the projector, will allow complete operation without the use of the remote control.
Up/Down/Left/Right arrow keys
Navigate through and make adjustments to the
On
Screen Display menus.
Arrow Up
/Down switch on from stand-by and recall
Source Selection menu.
Switches off to stand-by.
Menu
Activates the On Screen Display
menus. Navigates Menu pages.
-Focus-Esc
De-activates the On Screen Display and gives
access to the lens
ZOOM/FOCUS
adjustment fun-
ctions.
Auto
Selects
AUTO
Adjust
(automatic optimisation
of the displayed image).
Insert the batteries, taking care to match the polarity, as indi
-
cated in the battery recess of the remote (Fig. 17).
Change the batteries in the remote control if experiencing
difficulty in sending commands to the projector.
If the remote control is not to be used for a long period of time
remove the batteries. Replace all batteries at the same time;
do not replace one new battery with a used battery. If the bat-
teries have leaked, carefully wipe the case clean and replace
with new batteries.
1
2
1
2
3
-
C
L
A
S
S
1
L
A
S
E
R
P
R
O
D
U
C
T
5
0
0
L
I
N
K
Fig. 16
+
-
+
-
+
-
+
-
Four 1.5V�
AAA type�
batteries