Filter
Top Products
16
1
2
3
-
C
LA
SS
1
L
A
SER PRO
D
U
C
T
5
0
0
L
IN
K
R
C
I
20
0
5
L
I
G
H
T
Typically, the picture will appear after 15-20 seconds. Pressing
a key from 1-9 on the remote control selects the corresponding
input; pressing 0 selects the input active at the time the system
was last switched off.
If the system is switched on very soon after it was last switched
off, the lamp may fail to come on because it is too hot. In this
case just wait a few minutes to allow the lamp to cool.
Switching the system off
(Fig.15):
• from the remote control ( key)
• from the Projector keypad ( key).
If you wish to power off the system completely, wait at least one
minute in stand-by before setting the mains power switches on
the units to the “O” position or disconnecting the power supply
cables. This is to allow the fans in the Projector unit sufficient
time to cool the lamp.
Fig.15
In case the Projector unit is shut down (for example due to a
shut down of the projector unit by putting the switch in the “O”
position or by accidentally unplugging the power cord cable)
to re-boost the HT500LINK system it is necessary to shut down
the DigiOptic™ Image Processor and repeat the power-on pro
-
cedure described in point 1 and 2.
In case the connection with the fiber optics between the two unit
is interrupted (for example by unplagging one or more cable),
to restore the system, it is necessary to turn off the two units
through the main switches and once the connecectin is restored,
repeat steps 1 and 2 of the power-on procedure.