Filter
Top Products
ENGLISH
60
STANDBY
POWER ON
MAIN
PAGE
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
RNC-510
PANORAMA :
CENTER WIDTH
+
-------
0
DIMENSION
----
+
--
0
-
0
+
Off
PL I Ix MUSIC PARAMETER
RETURN:Back , : Se lec t
Press the CURSOR UP( )/DOWN( ) buttons to select the PL II(x) MUSIC PARAMETER, then press
the ENTER button.
1
When selecting the PL IIx MUSIC PARAMETER(or the PL II MUSIC PARAMETER)
When selecting the PANORAMA mode
This mode extends the front stereo image to include the
surround speakers for an exciting “wraparound” effect
with side wall imaging. Select “Off” or “On”(default
value:Off).
When selecting the CENTER WIDTH control
This adjusts the center image so it may be heard only
from the center speaker, only from the left/right
speakers as a phantom image, or from all three front
speakers to varying degrees.
The control can be set in 8 steps from 0 to 7(default
value : 0).
When selecting the DIMENSION control
This gradually adjusts the soundfield either towards the
front or towards the rear. The control can be set in 7
steps from -3 to +3(default value : 0).
Notes:
• Depending on whether “S/B CH” is set to “None” or not, you can select either the Dolby Pro Logic II surround
or the Dolby Pro Logic IIx surround and can adjust its parameters as desired only while listening in either the PL
II MUSIC mode or the PL IIx MUSIC mode.
(Refer to “When selecting the SPEAKER CONFIGURATION” on page 44.)
• In case of PL IIx MUSIC mode, only when original surround mode is “BYPASS” mode or 2 channel digital
signals from Dolby Digital sources, etc. are input, these parameter settings affect the surround effects.
Press the CURSOR UP(
)/DOWN( )
buttons to select the desired parameter.
2
Repeat the above steps and to adjust other parameters.
4
Press the CURSOR LEFT( )/RIGHT( )
buttons to adjust the selected parameter as
desired.
3
STANDBY
POWER ON
MAIN
PAGE
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
RNC-510
STANDBY
POWER ON
MAIN
PAGE
F
AV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP