Filter
Top Products
ENGLISH
40
Select the desired input source to enter its
label.
1
Press the LABEL button to enter the label
input mode.
Example ) When selecting VIDEO 1.
2
Select the character on the flickering digit.
3
Confirm your selection.
4
Repeat the above steps and to enter
the desired characters on the rest of the
digits.
5
Memorize the desired label.
6
Entering a label
Select the desired input source to be
rectified or cleared.
1
Repeat the steps ~ in “Entering a
label” procedure.
2
Correcting or clearing a label
• Each time the MULTI CONTROL knob is rotated,
the characters change as follows:
Blank ( )
Alphabets: A~Z, a~z
Numerals: 0~9
Symbols:
• You can select “VID 6” on the page 2 of “AUD 1”
on the remote control.
• This function can be operated on the input sources
except TUNER, TAPE MONITOR and 8 CH
DIRECT.
• You can select “VID 6” on the page 2 of “AUD 1”
on the remote control.
• Then the next digit will flicker.
• On up to 9 digits, the desired characters can be entered.
Note: If any of INPUT SELECTOR buttons is
pressed while entering a label, the label input
mode will be canceled.
• To clear a label, make a blank on each digit and
memorize it, then the label is cleared and its factory
input source will be displayed.
• If the LABEL button is pressed for more than 3
seconds, blanks will be made on all the digits at
once.
or
STANDBY
POWER ON
AUD1
TUNER VID1
CD VID2
T.MON VID3
AUX VID4
PHONO VID5
PAGE1
or
STANDBY
POWER ON
AUD1
TUNER VID1
CD VID2
T.MON VID3
AUX VID4
PHONO VID5
PAGE1