Sherwood P-965 Stereo Amplifier User Manual


 
ENGLISH
STANDBY
POWER ON
MAIN
P
A
G
E
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
RNC-510
or
DOWN
UP
CH/
ADJUST
32
Enter the test tone mode.
1
• The volume level of each channel can be adjusted easily with the test tone function.
Note: When speakers are switched off , the test tone function does not work.
Cancel the test tone function.
3
Adjusting each channel level with test tone
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
FL FC FR SR
Front Left Center Front Right Surround Right
SUB SL ( SC) or ( B L BR)
SUBwoofer Surround Left (Surround Center) (Surr. Back Left Surr. Back Right)
• Depending on the speaker setting(None or No), the
test tone of the corresponding channel is not
available.
• ( ): possible depending on whether the surround back
channel is set to 2 CH or 1 CH.
STANDBY
POWER ON
AUD2
SLEEP D/A
DIMM S.A/B
ROOM2 SUR.B
T.TON PURE
OSD PARA.
PAGE1
STANDBY
POWER ON
AUD2
SLEEP D/A
DIMM S.A/B
ROOM2 SUR.B
T.TON PURE
OSD PARA.
PAGE1
At each channel, adjust the level as desired
until the sound level of each speaker is
heard to be equally loud.
2
• You can select the desired channel and adjust its
level with repeating the steps
and in
“Adjusting the current channel levels” procedure.
Adjusting the current channel levels
Select the desired channel.
1
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources
or to suit your tastes.
• If you have performed the CH LEVEL SETUP procedure on the OSD menu, you can memorize the adjusted
channel levels into preset memory(PRESET 1, PRESET 2) and recall the memorized whenever you want.(Refer to
“SETTING THE CH LEVEL SETUP” on page 61.)
STANDBY
POWER ON
MAIN
P
A
G
E
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
RNC-510
CH.
SEL
or
• Each time this button is pressed, the corresponding
channel is selected as follows:
FRONT-L FRONT-C FRONT-R SURR-R
SUBWOOFER
SURR-L ( SURR-C) or ( BACK-L BACK-R)
• Depending on the speaker settings and surround
mode, etc., some channels cannot be selected.
• ( ): possible depending on whether the surround back
channel is set to 2 CH or 1 CH.
Note: When speakers are switched off, only
FRONT-L and FRONT-R channels can be
selected.