Filter
Top Products
ENGLISH
21
• The code is saved and the Pre-PROgramming mode is
resumed.
• When you do not want to save the code, select the
EXIT on the LCD screen or press the MAIN button.
Confirm that it is the right code by selecting
the SAVE.
8
Enter the 3 digit setup code aiming the
remote control at the REMOTE SENSOR on
the component.
7
• Your component will be turned off(or on in case of
this unit, etc.) when the right code is entered.
• Continue to enter the corresponding codes until your
component turns off(or on).
Operate the component using the
corresponding function buttons.
10
To resume the MAIN menu mode, press the
MAIN button twice briefly.
9
• Each time the MAIN button is pressed, the previous
mode is resumed.
• If any of the buttons fails to operate as they should,
start from the step
again to enter the next setup
code.
Notes:
• If the Manufacturer/Brand for your component is not
listed in “Set-Up Code Table” in the operating manual
of this remote control, please use the “ 2 Auto Scan
Method” on page 13 in the operating manual of this
remote control.
• Although each setup code is designed to work with
many different modes, certain codes may not work with
some models.( Also, certain codes may only operate
some of the functions available on a given model.)
Repeat the above steps
to for each of your other components.
11
STANDBY
POWER ON
MAIN
PAGE
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
RNC-510
For "001" :
For "102" :
001
102
AUD 1
001 SAVE
EXIT
DOWN UP
ENTER
STANDBY
POWER ON
MAIN
P
AGE
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
RNC-510
The selected device
MAIN
STANDBY
POWER ON
AUD 1
001 SAVE
EXIT
DOWN UP
ENTER