Filter
Top Products
26
Chapter 2 Creating Your Own Settings (Patches)
Muting Specific Strings
(STRING MUTE)
1. Turn the PARAMETER knob to “STRING MUTE.”
fig.02-46
2. Press [TUNER (STRING SEL)] to select the string you
want to mute.
The string number changes each time you press [TUNER
(STRING)], cycling through ALL → 1 → 2 → 3 → 4 → 5
→ 6 → ALL...
3. After you have selected the string number, press
[PATCH/VALUE] to select “On.”
Select “oF” (Off) if you do not want to mute the string.
fig.02-47
4. Repeat Steps 2 and 3 for any other strings you want to
set.
5. If you want to save the settings, carry out the Write
procedure (p. 26).
6. When you have finished making the settings, turn the
PARAMETER knob to return to “PLAY MODE.”
Storing the Settings (WRITE)
If you want to keep settings you have created (or changed),
use the “Write procedure” to save the settings to a patch.
* Switching patches (p. 13) or turning off the power without
first carrying out the Write procedure will cause the created
settings to be deleted.
* System parameter (p. 12) settings are saved automatically
when the PARAMETER knob is turned, even without the
Write procedure being carried out.
* Except for when “TUNER” is selected, if the dot in the display
is lit, it indicates that the patch settings have been changed.
fig.02-48
1. Press [WRITE].
The current patch number flashes in the display.
fig.02-49
2. Press [PATCH/VALUE] to select the save-destination
patch.
* This step is unnecessary if you want to save the settings to the
current patch.
* To cancel the Write procedure, press [SELECT (EXIT)].
3. Press [WRITE] once more.
The settings are stored in the save-destination patch.
* Note that once the Write procedure is carried out, any settings
that had been stored in the save-destination patch are
permanently lost.
On Off
Flash