Filter
Top Products
25
Chapter 2 Creating Your Own Settings (Patches)
Switching Sounds on External
Devices (PRG CHANGE)
You can transmit Bank Select messages (Control Change #0,
#32) and Program Change messages by switching the GI-20’s
patches.
This enables you to switch sounds from external sound
modules and patches of guitar effects processors.
When the transmission mode (p. 14) is set to MONO, these
messages are transmitted separately for each individual
string.
* The Bank Select messages and Program Change messages set
here are not transmitted when PC MASK (p. 29) is set to
“On.”
1. Turn the PARAMETER knob to “PRG CHANGE.”
fig.02-43
2. Press [SELECT] to select the parameter that is to be
changed.
The setting is changed each time you press [SELECT],
cycling through Bank Select MSB (CC #0) → Bank Select
LSB (CC #32) → Program Change in that sequence.
The display indicators light up as shown below
according to the parameter being set.
fig.02-44
3. If you want to change the string settings, press [TUNER
(STRING SEL)] to select the string numbers.
The string number changes each time you press [TUNER
(STRING)], cycling through ALL → 1 → 2 → 3 → 4 → 5
→ 6 → ALL...
fig.02-45
* You cannot make separate settings for individual strings when
the “transmission mode setting” (p. 14) is set to POLY.
If you switch the transmission mode setting to POLY after
making the settings for individual strings in MONO, the
Bank Select and Program Change for the first string are
transmitted.
4. Press [PATCH/VALUE] to change the value.
Repeat Steps 2–4 for other parameters you want to set.
For Bank Select values (MSB: CC #0, LSB: CC #32), select
Off and 0–127. For Program Change values (PC#), select
Off and 1–128. When set to Off, no Bank Select or
Program Change messages are transmitted, even when
you change GI-20 patch numbers.
5. If you want to save the settings, carry out the Write
procedure (p. 26).
6. When you have finished making the settings, turn the
PARAMETER knob to return to “PLAY MODE.”
Lit
Bank Select MSB (CC#0)
Lit
Bank Select LSB (CC#32)
Lit
Program Change
ALL 1st string 2nd string 6th string