Filter
Top Products
28
Other Features
■ Channel Linking
This interlinks the effect parameters for the two channels. You can use it with stereo recording or other
applications. Input parameters are not linked.
Linking
Hold down the [EDIT CH SELECT] button for channel 1 and press the [EDIT CH SELECT] button for
channel 2. Both [EDIT CH SELECT] buttons light up, showing that linking is in effect.
Canceling Linking
Press either one of the [EDIT CH SELECT] buttons to cancel the link. This makes only one button light up,
and lets you edit individual channels in the usual way.
When linked, the effects for channel 2 use the parameter values for channel 1 (the reverse is
not possible). Effect operations you perform while in this state are handled as settings for
channel 1, and so the setting values for channel 2 remain unchanged in memory. When you
cancel the link, the effects for channel 2 revert to the setting values they had before linking.
■ Copying Settings Between Channels
This copies the effect parameters to the other channel. You can use this at times such as when you want to
edit sets of parameters separately after making the same settings. Input parameters are not copied.
Copied settings are overwritten. The original settings cannot be restored after copying.
What follows is the procedure for copying from channel 1 to channel 2. To copy in the
opposite direction, follow the same procedure with the channel numbers reversed.
fig.LcdChannelCopy.eps
1. Press and hold the [EDIT CH SELECT] button for channel 2 for several seconds.
The message “COPY PARAM CH1 → CH2 OK?” is displayed.
2. Press [ENTER] to carry out the procedure. The setting values for channel 1 are copied to channel 2.
* If you don’t want to copy, press any button other than [ENTER].
■ Backup Patch
You can save user patch to computers or sequencers and load it from those. You can transfer your user
patch to another MMP-2 using this function. Operation from MMP-2 editor is shown on adopted
CD-ROM “ReadMe”.
Save patch to Computer (BACKUP)
1. Press [SYSTEM] button of MMP-2 several times and make it lights up
in orange. The screen turn to the status as right.
2. Press [PAGE] button several times to display “BACKUP” on screen.
3. Operate external device like computer to start sending/receiving signal.
If commencement of operation is necessary on MMP-2, press [ENTER].
Load patch from computer (RECOVER)
1. Press [SYSTEM] button of MMP-2 several times and make it light orange. The
screen turn to the status as right.