Filter
Top Products
96 C2900M-B (1/03)
CONNECTING PELCONET TO A CM9760-DT FOR REMOTE BROWSER
CONTROL
Refer to Figure 46. This configuration lets an operator view and control cameras on a PC using a
web browser. (The operator’s PC is not shown on the diagram.)
Figure 46. Using PelcoNet with CM9760-DT to Provide Remote Control of a 9760 Monitor Output
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
AUDIO IN
AUDIO OUT
INPUTS
OUTPUTS
RS-232/422/485
ETHERNET 10/100 BASE-T
POWER
PELCONET TRANSMITTER
TRANSPARENT DATA PORT
CM9760-MXB
USING INTERNET EXPLORER
SET TRANSPORT SETTINGS:
BAUD RATE
DATA BITS
PARITY
STOP BITS
VIDEO
SPECTRA “P”
PROTOCOL
CM9760-CC1
CM9760-KBD CM9505-UPS
PELCONET CM9760-DT SETUP
2-RX
3-TX
5-GND
CM9760-DT1
12VAC
1 ON
2 OFF
COM A
COM B
2-RX
3-TX
5-GND
NULL MODEM
CABLE NOT
SUPPLIED
SUPPLIED
CABLE
DIP SWITCH
COM 1 COM 2
COM 2 PROGRAMMED FOR 9760-DT
CAT 5
TO NETWORK
(LAN/WAN)
*
4800 OR 9600
8
EVEN OR ODD
1
NOTE: 4800 BAUD AND EVEN PARITY APPLIES TO CM9760-DT VERSION 2.07,
WHILE 9600 BAUD AND ODD PARITY APPLIES TO VERSION 3.0