Filter
Top Products
86 C2900M-B (1/03)
ᕡ Connect a PV130 Converter to the RS-232 port on the front of the NET101R/R-A receiver. The
data format should be 4800 baud, 8 data bits, no parity, and 1 stop bit.
ᕢ Connect the black and white striped wire from the power supply that comes with the converter
to the converter’s +12 VDC terminal and the solid black wire to the GND terminal.
ᕣ Connect RD(A) on the converter to terminal 2 on the wall block. Connect RD(B) on the converter
to terminal 1 on the wall block.
ᕤ Connect a 12 VAC power supply to terminals 3 and 4 on the wall block.
ᕥ Set DIP switch 6 on the KBD300A to ON to enable turbo pan operation or OFF to disable that
feature. The KBD300A will recognize Direct Mode automatically.
ᕦ Connect the wall block to the KBD300A with an RJ-45 straight cable.
ᕧ Connect the monitor.
ᕨ Refer to Figures 38 and 39. Splice the supplied DB9 cable into the Spectra/Esprit or receiver
cable. Use P protocol only.
To connect multiple Spectras/Esprits or receivers to the transmitter, daisy chain them in a
series through the TX- and TX+ cable and attach the video cables to inputs 2 through 4.
ᕩ Plug the supplied DB9 cable into the COM port on the transmitter. The data format should be
4800 baud, 8 data bits, no parity, and 1 stop bit.
ᕫᕾ Connect the camera’s video to the transmitter.