Filter
Top Products
Operating Other Components Using Remote Controller
41
2.
Press DISPLAY for 3 or more seconds while holding
down the REMOTE MODE button to which you want to
register the remote control code.
Once you entered the input mode, the remote indicator
will light.
3.
With the number buttons, enter the 5-digit remote control
code within 30 seconds.
• The registration is complete when the remote
indicator flashes twice. The remote indicator flashes
once slowly when registering the remote control
code fails. Try the registration again.
Remapping the Colored Buttons
The colored button assignment on the AV receiver's remote
controller can be remapped to match that on the remote
controller of the component whose remote control code you
programmed to REMOTE MODE. However, you will not be
able to remap the colored buttons if Zone 2 is selected.
1.
Hold down the REMOTE MODE button to map and A
(Red) simultaneously until the remote indicator lights
(about 3 seconds).
• Remapping is possible only for codes included in the
categories of the Remote Control Code List such as
DVD player and TV.
2.
Within 30 seconds, press the colored buttons from left to
right, in the order you want to remap.
• For example, if the colored buttons on the remote
controller of the other component are yellow, green,
blue, and red from left to right, press the buttons on
the AV receiver's remote controller in that order.
• Programming is complete when the remote indicator
flashes twice. The remote indicator flashes once
slowly when programming the remote control code
fails. Try the remapping again.
• Pressing any other button than a colored button
cancels the remap operation.
Resetting the REMOTE MODE Buttons
You can reset the remote control code registered in the
REMOTE MODE button to its default status. This operation
can be executed on a single REMOTE MODE button.
1.
Press HOME for 3 or more seconds while holding down
the REMOTE MODE button you want to reset.
The remote indicator will light.
2.
Within 30 seconds, press the REMOTE MODE button
again.
• Reset is complete when the remote indicator flashes
twice.
To reset all the remote controller settings, while holding
down RCV, press and hold down HOME until the remote
indicator lights (about 3 seconds). Press RCV again within
30 seconds. Reset is complete when the remote indicator
flashes twice.