Filter
Top Products
Advanced Settings
36
Setting item Default Value Setting Details
Sub Window Multi Set how to display preview thumbnails.
"Multi": Displays all the thumbnails of HDMI IN1,
2, 3, 4 and FRONT at once.
"Single": Displays each thumbnail individually.
Position Bottom/Lower
Right
Set the position to display preview thumbnails.
When "Multi" is selected for "Sub Window":
Select from "Top", "Bottom", "Left" and "Right".
When "Single" is selected for "Sub Window":
Select from "Upper Left", "Upper Right", "Lower
Left" and "Lower Right".
• If "Monitor Out" is set to "MAIN+SUB" and "Audio TV Out (SUB)" is set to "On"
– Set the audio output of the connected device to "2ch PCM".
– If the audio input is via other than HDMI, sound of the TV connected to the HDMI OUT SUB jack
will not be output.
Auto Standby
Setting item Default Value Setting Details
Auto Standby On/Off This setting places the unit on standby
automatically after 20 minutes of inactivity
without any video or audio input.
"On": The unit will automatically enter standby
mode ("ASb" will light).
"Off": The unit will not automatically enter
standby mode.
• "Auto Standby" is appeared on the display
and menu screen 30 seconds before the
Auto Standby comes on.
• "Auto Standby" does not work when Zone 2
is active.
• Default values vary depending on the
regions.
HDMI Through Off Enable or disable "Auto Standby" while "HDMI
Through" is on.
"On": The setting will be enabled.
"Off": The setting will be disabled.
• "HDMI Through" cannot be set to "On" if
"Auto Standby" is set to "Off".
• When "HDMI Through" is used, the power consumption increases even when the unit is on standby.
However, the increase in power consumption is kept to a minimum by automatically entering the
HYBRID STANDBY mode, where only the essential circuit is operating.