Filter
Top Products
Advanced Settings
25
Setting item Default Value Setting Details
Back 100Hz Select the frequency to start outputting bass
frequencies (crossover frequency) for each
channel from "40Hz" to "200Hz".
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
• In the following cases, this setting will be set to
"None":
– "Surround" is set to "None".
– "Front Speakers Type" is set to "Bi-Amp".
– "Powered Zone 2" is set to "Yes" and also
Zone2 is set to on.
• This setting cannot be set to "Full Band" unless
"Surround" is set to "Full Band".
Height None Select the frequency to start outputting bass
frequencies (crossover frequency) for each
channel from "40Hz" to "200Hz".
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
• In the following cases, this setting will be set to
"None":
– "Surround" is set to "None".
– "Front Speakers Type" is set to "Bi-Amp".
– "Powered Zone 2" is set to "Yes" and also
Zone2 is set to on.
• This setting cannot be set to "Full Band" unless
"Front" is set to "Full Band".
Back ch 2ch Select the number of channels of the connected
surround back speaker.
"1ch": When one speaker is connected (Connect to
the BACK or HEIGHT L terminal)
"2ch": When two speakers are connected
• The setting cannot be changed if "Surround" or
"Back" is set to "None".
LPF of LFE 120Hz Set the low-pass filter for LFE (low-frequency
effect) signals in order to pass lower frequency
signals than the set value and thus cancel
unwanted noises. The low-pass filter will be
effective only on sources with LFE channel.
Set a frequency from "80Hz", "90Hz", "100Hz" and
"120Hz".
"Off": Do not use this function
Setting item Default Value Setting Details
Double Bass ----- Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer.
"On": Bass output will be boosted.
"Off": Bass output will not be boosted.
• The setting will not automatically be configured
even if you performed the automatic speaker
setup.
• If "Subwoofer" is set to "No" or if "Front" is set to
other than "Full Band", the setting will be fixed
to "-----".