Filter
Top Products
46
Multi-room system connections
U.S.A. and Canadian models (Xantech Multi-Room Systems)
Do not plug in the power cord until all connections have been made.
When making connections 1 through 5, be sure to connect the units as shown in the diagram below. Do not make a mistake when connecting the units.
A. Operating components displaying Onkyo's z mark from the sub-room
Components mounted in a rack should be connected as shown below to enable remote control operation.
1. Set up the components (a) displaying
Onkyo's z mark.
2. Connect the sub-room speaker cables to the
FRONT REMOTE SPEAKERS connectors
on the TX-DS656. (1)
3. Install Connecting Block in the main room,
then connect it to the TX-DS656. (2)
4. Install the Remote Sensor in the sub-room,
then connect it to the Connecting Block in
the main room. (3)
1. Connect the components (b) to the TX-DS656.
2. Make the connections described above in
steps 2 through 4 of section A.
3. Install Emitter (c) so that its sensor is
directed toward these components, then
connect it to the TX-DS656. (4)
■ Operating components which are positioned
out of the range of the emitter installed as
described above
4. Connect the components (d) to the TX-DS656.
5. Install another Emitter (e) so that its sensor
is directed toward these components, then
connect it to the Connecting Block. (5)
Connection diagram
MJ
27122482
ANTENNA
AM
R
V
L
OUT
IN
VIDEO-1
OUT
IN
VIDEO-2
OUT
IN
OUT
IN
IN
IN
TAPE-1
TAPE-2
DVD
OUT
IN
OUT
R
L
R
L
PHONO
CD
GND
(PLAY)
(REC)
(PLAY)
(REC)
R
L
CENTER
SUBWOOFER
SURROUND
FRONT
R
L
R
L
V
PRE OUT
FRONT
R
L
R
L
DIGITAL INPUT
DIGITAL 1
(OPTICAL)
DIGITAL 2
(COAXIAL)
OUT
IN
REMOTE CONTROL
R
L
AC OUTLETS
MONITOR
OUTPUT
SURROUND
CENTER SUBWOOFER
DIGITAL 3
(COAXIAL)
S
MULTI
CHANNEL
INPUT
L
RR
L
S
IN
SURROUND SPEAKERS
FRONT
SPEAKERS
MAIN
CENTER
SPEAKER
AC 120V 60Hz
SWITCHED
TOTAL 120W 1A MAX.
FRONT REMOTE SPEAKERS
FM
75
FM
300
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
AVIS
CAUTION: SPEAKER IMPEDANCE
6 OHMS MIN. / SPEAKER
TX-DS656
L
R
LR
(e) (c)
MAIN Speaker (Main Room)
Connecting block
Emitter
Power supply
REMOTE Speaker
(Sub-room)
Remote sensor
Main
speaker
Main
speaker
Remote
speaker
Remote
speaker
1. Components(b)
TX-DS656
Connecting
block
4. Components(d)
Power
supply
Remote
control
Remote
sensor
MAIN ROOM SUB-ROOM
5. Emitter
(e)
3. Emitter
(c)
B. Using a remote controller to operate components not displaying Onkyo's z mark from the sub-room
MAIN ROOM SUB-ROOM
4. Remote sensor
Remote
control
TX-DS656
1. Onkyo components (a)
Main
speaker
Main
speaker
2. Remote
speaker
2. Remote
speaker
3.Connecting
block
Power
supply