Filter
Top Products
24
Level Calibration using remote controller
You can perform level calibration (channel balance setting) independ-
ent of the other speaker system settings.
In the following procedure, use the remote controller unless otherwise
specified.
1. Press the POWER button.
2. Press the TEST TONE button.
Press the TEST TONE button again. A test tone is output to each
speaker in the following sequence:
Left front speaker → Center speaker → Right front speaker →
Right Surround speaker → Left Surround speaker → Subwoofer
(Returns to Left front speaker)
After a few seconds, the test tone automatically travels to the next
speaker.
3. While the test tone is output, adjust the output level of the
speaker using the LEVEL y or u button.
The test signal stays at the same speaker while adjustment is in
progress.
You can change the channel to which the test tone is output by
pressing the CH SEL button.
4. Repeat step 3 to adjust the output level of all speakers.
5. When the adjustment is complete, press the TEST TONE
button.
The test tone output stops.
Speaker system setup
MUTING
POWER
SLEEP
DVD VIDEO-1
VIDEO-2
TAPE-1 TUNER PHONO C D
SOURCE SELECTOR
DVD
DISC
PAUSE
/
STEP
VOLUME
TONE
TEST
MODE
SUR
VIDEO-3
M
TI-CHUL
INPUT
TAPE-2
POWER
POWER
TAPEC D
TV/
VCR
VOLUME
TUNER
/
REMOTE
SPEAKER
CURSOR
ENTER
REMOTE CONTROLLER
CH SEL
SENDING/
LEARN
SUBROOM
C H
AB
LEVEL
DIMMER
PRESETGROUP
LEARNED
PROGRAMMABLE AREA TV
VIDEO
/
SUBTITLE
ON
/
OFF
RC-373M
POWER button
TEST TONE
button
LEVEL y/u
button