Filter
Top Products
22
d
* Speaker Distance *
Front = 12 ft
3.6 m
Center = 12 ft
3.6 m
Surround = 7 ft
2.1 m
Speaker system setup
On-screen speaker system setup
In the following procedure, use the remote controller unless otherwise
specified.
1. Press the POWER button.
2. Press the ENTER button.
The Menu appears on the TV screen. (a)
3. Select "System Setup" using the y or u cursor button, then
press the s cursor button.
The System Setup screen appears. (b)
4. Select "Speaker Setup" using the y or u cursor button, then
press the s cursor button.
The Speaker Setup screen appears. (c)
5. Select the desired speaker type ("Subwoofer", "Front",
"Center", or "Surround") using the y or u cursor button and
enter a speaker setting ("YES"/"NO" or "LARGE"/
"SMALL"/"NONE") using the a or s cursor button.
For further information, see "What is System Setup?" on page 21.
6. Press the ENTER button.
You are now back to the System Setup screen.
7. Select "Speaker Distance" using the u cursor button, then
press the s cursor button.
The Speaker Distance screen appears. (d)
8. Select the desired speaker type ("Front", "Center", or "Surround")
using the y or u button and set the distance to the selected speaker
using the a or s cursor button.
You can enter the speaker distance in units of meters (m) or feet (ft).
If "meters" is used, you can enter a distance within the range of
0.3m-9.0m in 0.3m increments. If "feet" is used, a distance within
the range of 1 ft.-30 ft. can be entered in 1 foot increments. An
unacceptable distance setting will be corrected automatically. In
either case, an appropriate delay time
*
will be set automatically
according to the distance you enter.
* "Delay time" is set according to the distance from the listening
position to the Center and Surround speakers for an optimized
surround sound.
Note:
On the Speaker Distance screen, the speaker whose parameters
have been set to "NO" in step 6 is not shown.
9. Press the ENTER button.
You are now back to the System Setup screen again.
10. Select "Level Calibration" using the u cursor button, then
press the s cursor button. (e)
The Level Calibration screen appears and, at the same time, a test
tone signal is output to each speaker channel in the following
sequence:
Left front speaker → Center speaker → Right front speaker →
Right Surround speaker → Left Surround speaker → Subwoofer
(Returns to Left front speaker)
After a few seconds, the test tone automatically travels to the next
speaker. You may use the y or u button to immediately move to
the next speaker.
11. While the test tone is output, adjust the output level of the
speaker .
The test tone stays at the same speaker while adjustment is in
progress.
The adjustment range is -12dB to +12dB (-30dB to +12dB for
Subwoofer).
12. When the output level of all speakers have been adjusted, press
the ENTER button.
The test tone signal output stops, and the System Setup screen is
displayed.
a
b
c
*** Menu ***
Input Selector
Rec Selector
Surround Setup
Screen Setup
System Setup
** System Setup **
Speaker Setup
Speaker Distance
Level Calibration
Starting
the Test Signal.
* Speaker Setup *
Subwoofer = YES
Front = LARGE
Center = SMALL
Surround = SMALL
e
* Level Calibration *
Left = 0dB
Center = 0dB
Right = 0dB
R-Sur. = 0dB
L-Sur. = 0dB
Subwoofer = 0dB