Filter
Top Products
OMWT-SOFT-OPC Server OMWT-SOFT-OPC Server .ini File Format
N
27
Wireless Analog Output
(OMWT-ANGOUT)
[Device
n
]
- S
ection name.
Address
- serial number of the sensor.
N
odalA
dd
ress
– node where the output will be sent. Defaults to 0 for the
OMWT-REC323-600 Receiver. For OMWT-RECIP, the node number
represents each receiver starting at 1. If set to 0, OMWT-SOFT-OPC
will send the output packet to all nodes.
DeviceType
- Device type. (DeviceType= OUTPUTANALOG)
PollTime
- How often to poll the device or wait for packet. (ms) Defaults to
0 for outputs.
Label
- Name used for the device (and Topic) (typically
OUTPUTANALOG1).
Log
- Enable/disable logging of device.
LogDecimalPlaces
- Number of decimals to create when logging.
Description
- General purpose description.
Cal1Raw
- Two point calibration point 1 (default 0).
Cal2Raw
- Two point calibration point 2 (default 4095).
Cal1Engr
- Two point calibration engineering units for point 1 (default 0).
Cal2Engr
- Two point calibration engineering units for point 2 (default
100).
Units
- units label (default "%").
Description
- Generic description field
OutTries
– number of times to send the output packet. (default 10)
OutInterval
– (in milliseconds) – the interval of time between sending
output packets. (default 1000).