Filter
Top Products
OMWT-SOFT-OPC Server OMWT-SOFT-OPC Server .ini File Format
N
17
Logging
[Logging]
- section name
L
ogRate
- 0: no logging; 1-100000 logging interval in seconds. 5 sec or
greater OMWT-SOFT-OPC opens and closes the log file at every
logging interval. Less than 5 OMWT-SOFT-OPC leaves the file open
until OMWT-SOFT-OPC is terminated or “Server.Logging.LogRate” is
set to 0 or 5 and greater.
LogFile
- full pathname for the log file - default "OMWT-SOFT-
OPC.LOG"
OfflineIndicator
- character or string to indicate offline - NULL: last value
LogErrors
- 1 - log runtime network errors to OMWT-SOFT-OPC.ERR. 0
- do not log errors
IP Addresses
[IP Addresses]
– section name (for OMWT-RECIP receivers)
IPWaitPort
– port number that OWMT-SOFT-OPC will wait for
connections initiated by an IP receiver. (default is 1060)
ForwardPort
– port number that OWMT-SOFT-OPC will wait for
connections to forward received packets. (default is 0 which means
disabled) OWMT-SOFT-OPC will forward received packets through
this connection. Each packet has the following format: sensor
packet,node number, node description, sensor label. The INI
parameter FowardAll in the [Server] section controls what packets get
sent.
DIGITAL I/O
[Device
n
]
- Section name.
Address
– serial number of the sensor.
DeviceType
- Device type. (DeviceType=DIGITAL)
PollTime
- How often to poll the device. (ms)
Label
- Name used for the device (and Topic).
Log
- Enable/disable logging of device.
OutputOnDemand
- Output is initiated on demand or during poll.
DescriptionA
- General purpose description.
DescriptionB
- General purpose description.