Filter
Top Products
27NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373
CONNECT THE KEYPADS
Each keypad controls a specic zone. The RJ-45 terminated CAT-5 cable that
runs to each keypad is connected to the ZR-6 MultiZone Receiver’s keypad
ports labeled: Zone 1, Zone 2, Zone 3, Zone 4, Zone 5 and Zone 6. The zone
port to which each keypad connects defines the zone controlled by that
keypad. For example: the keypad connected to Zone 1 will always control
Zone 1. All RJ-45 terminated CAT-5 cables utilize the T568A wiring convention
(Figure 14).
CONNECT THE SLAVE ZR-6 MULTIZONE RECEIVER
Multiple ZR-6 MultiZone Receivers can be combined to create up to an
eighteen-zone system. The Expansion ports serially connect the multiple ZR-6
MultiZone Receivers with RJ-45 terminated CAT-5 cables using the T568A
wiring convention. One receiver must be designated as the Master, the others
as Slave(s). If more than one Slave is used, please note that the expansion out
of Slave 2 connects to the expansion in of Slave 1. The expansion out of Slave
1 then connects to the expansion in of the Master. Do not connect more than
one Slave directly to a Master. All MicroFlashers for source control must be
connected to the Master and not to the Slave. IR from the keypads connected
to the Slave will be routed to the Master via the expansion ports.
CONNECT THE AM AND FM ANTENNAS
FM DIPOLE ANTENNA
The included FM dipole antenna connects to the female 75-ohm
coaxial connector. The antenna is then positioned and mounted
for best reception. An antenna must be connected to each ZR-6
MultiZone Receiver chassis in Master/Slave configurations.
AM LOOP ANTENNA
The included AM loop antenna connects with its bare-wire ends
to the spring-loaded terminals. The antenna is then positioned and
mounted for best reception. An antenna must be connected to each
ZR-6 MultiZone Receiver chassis in Master/Slave configurations.
CONNECT THE 12V OUTPUTS
The Global 12V output triggers an external device whenever any zone is active. The Zone 4, 5 and 6 12V Outputs trigger an external device
whenever the respective zone becomes active. A common use would be to turn on a 12V trigger-equipped Niles Systems Integration
Amplier connected to the pre-amplier outputs. The 12V outputs can also be used to trigger a Niles AC-3 Voltage-Triggered AC Power
Strip (FG00242) to automate power turn-on and turn-off of connected sources.
SYSTEM INSTALLATION
INPUT 2 OR iPod CASCADE OUT
INPUT 2 OR iPod CASCADE OUT
Figure 15. Connecting AM/FM Antennas to the ZR-6
MultiZone Receiver
ZR-6 MULTIZONE RECEIVER SYSTEM INSTALLATION
(CONTINUED ON NEXT PAGE)
8= BROWN
7= BROWN/WHITE
6= ORANGE
5= BLUE/WHITE
4= BLUE
3= ORANGE/WHITE
2= GREEN
1= GREEN/WHITE
Figure 14. T568A wire termination
DS00643A-1 ZR6 Manual.indd 27 7/22/08 11:57:59 AM