Filter
Top Products
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-437334
SYSTEM CONFIGURATION
Press the Band button to toggle the “Y” on or off in the
highlighted zone. Only zones with a “Y” will respond to whole
house turn on.
123456
YYY
PARTY
MASTER
NOTE: IN THIS EXAMPLE ZONES 1, 2 AND 3 ARE CONFIGURED FOR
PARTY MODE.
After “6” on the Master, it will toggle to “1” on the first
connected Slave. After “6” on the last connected Slave it will
toggle back to “1” on the Master.
Repeat these steps until all of the desired zones have been set for
the desired Party mode operation.
To continue to the next system configuration step,
PAGE MODE
VOLUME
, press the Set button once.
To save the settings and exit the configuration mode,
simultaneously hold down the Band and Set buttons. After the
ZR-6 saves the information, [RELEASE BUTTONS TO CONTINUE]
appears on the display. The ZR-6 will return to the normal operating
mode.
PAGE MODE VOLUME
The paging volume level for the selected zones is adjustable.
Since the paging volume level will be the same for all zones,
we suggest setting a comfortable level in the room that will
be used most frequently, or in the smallest room. While in the
configuration mode (see above), press the Set button until [PAGE
MODE VOLUME = XX] shows in the display.
PAGE M O DE
VOL UME = 60
Press the + button to increase the paging volume. Press the - key
to decrease the paging volume. The factory default setting is 60.
The volume range is from 0 to 99.
PAGE M O DE
VOL UME = 34
To continue to the next system configuration step,
Zone 4 Pre-Out
,
press the Set button once.
To save the settings and exit the configuration mode,
simultaneously hold down the Band and Set buttons. After the
ZR-6 saves the information, [RELEASE BUTTONS TO CONTINUE]
appears on the display. The ZR-6 will return to the normal operating
mode.
ZONE 4 PRE-OUT
The ZR-6 MultiZone Receiver is equipped with Zone 4 pre-amplifier
outputs that enable the use of a separate outboard power amplifier.
While in the configuration mode (see above), press the Set
button until the display shows [ZONE 4 PRE-OUT VARIABLE].
The default setting is for the preamplifier outputs to be variable (the
output level is controlled by the ZR-6 volume control).
ZONE 4 PREOUT
VARIABLE
To change these outputs to a fixed volume level, press the Band
button. The display will show [PRE-OUT 4 FIXED]. The Zone 4
Output is now set to +6dB relative to the selected source device
input level.
ZONE 4 PREOUT
FIXED
To continue to the next system configuration step, Zone 5 Pre-Out,
press the Set button once.
To save the settings and exit the configuration mode,
simultaneously hold down the Band and Set buttons. After the
ZR-6 saves the information. [RELEASE BUTTONS TO CONTINUE]
appears on the display. The ZR-6 will return to the normal operating
mode.
CONFIGURING THE ZR-6 MULTIZONE RECEIVER
DS00643A-1 ZR6 Manual.indd 34 7/22/08 11:58:10 AM