Filter
Top Products
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-437336
Available source device names:
Radio (default Source 1) iPod (default Source 2)
• N/A
• Blu-ray
• Cable
• Cable 2
• Cable 3
• CD
• CD 2
• CD 3
• CD Ch
• CD Ch 2
• CD Ch 3
• DMS
• DMS 2
• DMS 3
• DMS 4
• DVD
• DVD 2
• DVD Ch
• DVD Ch 2
• DVR
• HDTV
• MP3
• DVD Ch 2
• Music
• Music 2
• PC
• SAT Radio
• SAT Radio 2
• SAT TV
• SAT TV 2
• SAT TV 3
• TV
• TV 2
• Video
• Video 2
The corresponding Solo-6 MD Master Keypad screen displays are
shown in an appendix at the end of this document.
To continue to the next configuration step, ERASING TUNER PRESET
INFORMATION, press the Set button.
To save the settings and exit configuration mode, simultaneously
hold down the Band and Set buttons. After the ZR-6 saves the
information, [RELEASE BUTTONS TO CONTINUE] appears on the
display. The ZR-6 will return to the normal operating mode.
ERASING TUNER PRESET INFORMATION
While in configuration mode, press the Set button until the display
shows [ERASE PRESETS?]
ERASE PRESETS?
-/NO +/YES
Press + to erase all 20 tuner presets stored into the ZR-6. The
display will show [PRESETS ERASED].
PRESETS ERASED
Press the – button to exit and move to the next step without erasing
any of the presets.
To continue to the next configuration step, RESTORING FACTORY
D EFA U LTS, press the Set button.
To save the settings and exit configuration mode, simultaneously
hold down the Band and Set buttons. After the ZR-6 saves the
information, [RELEASE BUTTONS TO CONTINUE] appears on the
display. The ZR-6 will return to the normal operating mode.
RESTORING THE FACTORY DEFAULTS
While in configuration mode, press the Set button until
[FACTORY RESET] appears on the display.
FACTORY RESET
-/NO +/YES
Press + to erase all configuration data. All Master/Slave, zone
linking, paging, party mode, bass, treble, and loudness settings
will return to the factory default. The display will show [CONFIRM
ERASE].
CONFIRM ERASE
-/NO +/YES
Press the + button to confirm the erase procedure. The display will
show [MASTER DEFAULT RESTORED].
MASTER
DEFAULT RESTORED
Press the – button (at either screen) to exit and move to the next
step without erasing any information.
To continue to the first configuration step, MASTER/SLAVE, press
the Set button.
To save the settings and exit configuration mode, simultaneously
hold down the Band and Set buttons. After the ZR-6 saves the
information, [RELEASE BUTTONS TO CONTINUE] appears on the
display. The ZR-6 will return to the normal operating mode .
SYSTEM CONFIGURATION
CONFIGURING THE ZR-6 MULTIZONE RECEIVER
DS00643A-1 ZR6 Manual.indd 36 7/22/08 11:58:12 AM