Filter
Top Products
64
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
Video output
Video Connection
The video signals of this unit’s ZONE2 video output terminal are
played by the ZONE2 TV.
VIDEO
IN
ZONE2
VIDEO
COMPONENT
VIDEO IN
Y P
B PR
MAIN ZONE ZONE2
This unit
NOTE
• It is not possible to output video signals input to the HDMI terminals
to ZONE2.
• When using component output terminal 2 for ZONE2 video signal
output, set “Manual Setup” – “Option Setup” – “Component2
Output” (vpage87) in the menu to “ZONE2”.
• The menu screen is not output.
Playback
1
Press Z2 or Z3 to switch the
remote control operating mode.
The remote control unit switches to the
operating mode for ZONE2 or ZONE3.
2
Press ON to turn on the ZONE2
or ZONE3 power.
The or indicator on the
display lights.
• When
STANDBY is pressed, ZONE2 or
ZONE3 turns off.
• Power in ZONE2 or ZONE3 can be turned
on or off by pressing SOURCE ON/OFF on
the main unit.
3
Press INPUT df.
The audio signal of the selected source is output to ZONE2 or
ZONE3.
• Turn
INPUT SELECTOR after
pressing ZONE SELECT on the
main unit to select an input
source.
When power for both MAIN ZONE and ZONE2 is set to ON, power of
the MAIN ZONE only can be turned off. Select “AMP” in step 1 then
press STANDBY.
Adjusting the volume
Use VOLUME to adjust the volume.
GAdjustable rangeH
– – –
–80dB – –40dB – 18dB
(When the “Volume Display” (vpage86) setting is “Relative”)
GAdjustable rangeH
0 – 41 – 99
(When the “Volume Display” (vpage86) setting is “Absolute”)
• At time of purchase, “Volume Limit” (vpage85) is set to “–10dB
(71)”.
Turn VOLUME after pressing ZONE SELECT on the main unit to adjust
the sound volume.
Turning off the sound temporarily
Press MUTE.
The sound is reduced to the level set at “Mute Level” (vpage86) in
the menu.
• To cancel, either adjust the volume or press MUTE again.
• The setting is canceled when the zone’s power is turned off.
You can adjust the tone and volume for ZONE2 and ZONE3 in “Zone
Setup” (vpage85) in the menu.