Filter
Top Products
58
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
Convenient functions
Sleep timer function
The power automatically goes into standby once the set time has
elapsed.
This is convenient for playing sources while going to sleep.
1
Press AMP to set the remote
control unit to amplier operation
mode.
2
Press SLEEP and display the time
you want to set.
The indicator on the display lights.
• If SLLEP on the main unit is pressed,
the same function as with the remote
control unit can be obtained.
• The time switches as shown below each time
SLEEP is pressed.
OFF 10 min 20 30 40 50
6080 7090100
110
120
To cancel the sleep timer
Press SLEEP to set “OFF”.
The indicator on the display turns off.
• The sleep timer setting is canceled if this unit’s power is set to
standby or turned off.
• When power to the main zone is turned off with the sleep timer,
power in ZONE2 and ZONE3 are also turned off.
Adjusting the volume of the speakers
You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
n Adjusting the volume of the different speakers
1
Press AMP to set the remote
control unit to amplier operation
mode.
2
Press CH LVL.
Front L
Front R
Center
Subwoofer
Surround L
Surround R
S.Back L
S.Back R
Fader
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
CHANNEL LEVEL
Select
Front Rear
3
Use ui to select the speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
4
Use o p to adjust the volume.
• In the case of a subwoofer, pressing o when it is at “–12 dB” will
change the setting to “OFF”.
• When a headphone jack is inserted, the headphone channel level
can be adjusted.
• When the input mode setting is “7.1CH IN”, you can adjust the
channel level while the 7.1CH INPUT connector is being used. In
that case, “7.1CH IN Level” appears at the top of the screen.
n Adjusting the volume of groups of speakers
(Fader function)
This function lets you adjust (fade) the sound all at once from the
front (front speaker / front height speaker / front wide speaker /
center speaker) or rear (surround speaker / surround back speaker).
1
Press AMP to set the remote
control unit to amplier operation
mode.
2
Press CH LVL.
Front L
Front R
Center
Subwoofer
Surround L
Surround R
S.Back L
S.Back R
Fader
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
CHANNEL LEVEL
Select
Front Rear
3
Press i to select “Fader”, then select the item to be
adjusting using o p.
4
Use o p to adjust the volume of the speakers.
(o : front, p: rear)
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker is adjusted
to the lowest value of –12 dB.