Filter
Top Products
6
SETTING UP
To output analog audio signals to another
audio component
Connect the source component’s analog line input jacks
to this unit’s LINE OUT (RCA) jack.
Notes
• To connect the mono PMD680 LINE OUT to a stereo input,
a Y-adaptor cable can be used.
To record from or output through a telephone
wire
Connect the phone line to the TELEPHONE IN/OUT
jack.
Notes
• Do not start recording until the telephone connects with
the dialed telephone number.
• Please be advised that connecting the PMD680 to a
telephone line is illegal in some countries.
Connecting Microphones
Connect the microphones as shown below.
With the PMD680, you can connect a microphone (for
mono recording) to either the MIC 1 (XLR) jack or the
MIC 2 (1/4" phone) jack.
Notes
• Take care to not connect or disconnect microphones while
recording. This may result in unwanted sounds in the
recording.
Connecting Analog
Components
The following illustrations show you how to connect
analog audio components for recording or playback.
To record from analog audio components
Connect the source component’s analog line output
jacks to this unit’s LINE IN (RCA) jack.
Notes
• To connect a stereo source to the mono PMD680 LINE IN,
a Y-adaptor cable can be used.
MIC (1/4")
MIC (XLR)
or
TAPE DECK, etc.
TAPE DECK, etc.
LINE OUT
LINE IN
Phone
RJ-11 splitter
Wall jack