Filter
Top Products
4
SETTING UP
Power On/Off
Power on
Sliding the power switch rightward makes power on
and off in turn.
When power is applied from the battery or the AC
adapter, sliding the power switch make the unit enter
standby status.
Sliding the power switch rightward in standby status,
the main power is put on and the unit detects existence
of the card in the card slot.
If the card in the slot is formatted complying with the
units specification, the display blinks showing TOC
(Tabel Of Contents) creating message, then enters stop
status.
About the display in stop status, please refer to the
chapter of "Data Display" on page xxx.
If the card is not formatted complying with the unit
specification, the display shows unformat message.
If the card does not exist in the card slot, the display
shows no card message.
Power Off
Sliding the power switch rightward while main power
is on, the main power is put off after necessary process
for shutdown, and the unit enters standby status.
While recording or rec-pause, the main power is not put
off even if the power switch is operated.
Setting the Date and Time
Before operating your PMD680, perform the following
operations to set the current date and time.
The current date and time are recorded automatically at
the beginning of each recording.
1 With the power off, slide POWER to the right
while holding down DISPLAY (TIME/DATE).
The unit turns on and enters the date/time
setup mode.
2 Press 1˜4 or ¢˜¡ to set the year, then
press PLAY/PAUSE (3˜8) to enter.
3 Press 1˜4 or ¢˜¡ to set the month,
then press PLAY/PAUSE (3˜8) to enter.
4 Press 1˜4 or ¢˜¡ to set the day, then
press PLAY/PAUSE (3˜8) to enter.
5 Press 1˜4 or ¢˜¡ to set the hour, then
press PLAY/PAUSE (3˜8) to enter.
6 Press 1˜4 or ¢˜¡ to set the minute,
then press PLAY/PAUSE (3˜8) to enter.
7 The seconds start counting from 00 and the
unit automatically returns to its normal
operation mode (stop status) immediately
after you press DISPLAY (TIME/DATE) key.
Pressing PLAY/PAUSE (3˜8) instead of
DISPLAY (TIME/DATE) key, the minute
setting is entered and the menu returns to year
setting menu (step 2).
8 Pressing STOP (7) before setting minute
cancels all the date/time setting.
OVER
5
5
5
5
5
5
5
5
5
5
5
5