Filter
Top Products
18
PLAYBACK and EDITING
Marking and EDL Playback
Marking Operation
Pushing REC/MARK key during playback, playback
pause, and recording, a mark is placed at the location
where REC/MARK key is pressed.
Putting mark helps access to the marked location, and
further, in EDL Playback mode, the marks can be used
to specify the skip start point, skip destination, and
repeat points.
Every time a mark is placed, the total quantity of mark
is displayed for one second instead of track number
(TRACK icon turns off). Then, the display resumes track
number display (TRACK icon turns on).
Note
• The marked location data is stored in the EDL file in
the card.
• The updated marked location data is written in the
EDL file when the units enters STOP status.
• The mark placed by pressing REC/MARK key is not
yet assigned attributes (Skip, -a,-b) for EDL Playback.
• The maximum number of mark placed in a card is 255.
Attempt to place a mark while already 255 marks
were placed, mark full message, "FUL -p 255", is
displayed for 3 seconds. The mark is not put any more.
AUTO MARK
AUTO MARK mode automatically places a mark when
recording starts from rec-pause status.
In silent skip recording mode as well, a mark is placed
every time when recording is resumed detecting sound
from the rec-pause status made by silence.
The total quantity of mark is displayed for one second
istead of track number (TRACK icon turns off). After
one second, the display resumes track number display
(TRACK icon turns on).
Pressing AUTO MARK key turns on and off AUTO
MARK mode. When auto marking mode is on,
"A.MARK" icon is displayed.
For operation to set Auto Mark mode, refer to
"Recording Behavior Setting" on page xxx.
Note
Since the maximum number of marks in a card is 255,
when rec-pause occurs after 255 marks were placed by
auto marking, auto marking mode is automatically
removed. "A.MARK" icon turns off, and mark full
message "FUL –p 255" is displayed for 3 seconds.
Silent skip works after this as well, but a mark would
not be put anymore.
MARK SELECTERASE
REPEAT
JUMP TO MARK
1 / 4 ¢ / ¡
STOP (7)REC / MARK
PLAY / PAUSE
(6)
REC
-dB
50 40 24 6 2 0
A.MARK
TRACK
TIME
12
OVER
REC
-dB
50 40 24 6 2 0
TRACK
TOTAL TIME
12
OVER
A.MARK indicator turned off.
Displayed for 3 seconds
When a mark is placed, the total
quantity of mark is displayed
(total quantity of mark = 192)
After one second, the display
resumes track number display
(track number = 124)
-dB
50 40 24 6 2 0
TIME
12
OVER
-dB
50 40 24 6 2 0
TRACK
TIME
12
OVER