Filter
Top Products
1
SETTING UP
Features
• MPEG I Layer 2 compression technology for recording
and playback of mono MPEG audio.
• Recording and playback to and from approved
PCMCIA PC Cards (ATA flash or hard disk card).
• MS-DOS compatible file system.
– MPEG Files in .wav, .mpg, and .bwf.
– PCM files in broadcast .wav and .bwf.
• A wide variety of input and output jacks.
– Microphone input jacks (XLR and 1/4”).
– Line level RCA input and output jacks.
– Digital coaxial output jack (SPDIF, 48kHz).
– Telephone jack (input/output).
• Three recording modes; LP, MP, and SP.
• Bit rate is assigned to each mode by presetting.
• Three record level options: manual, manual with
limiter, and automatic level control (ALC).
• Skip playback and repeat playback using a built-in
EDL (Edit Decision List).
• In pre-recording mode, 2 seconds recording prior to
the recording start is done.
Unexpected chance of starting recording is not missed.
• 3-way power supply:
– 8 Alkaline AA (R6) batteries
– AC adaptor (supplied)
– Rechargeable Ni-Cad pack (optional)
• ANC (Ambient Noise Control) switch for eliminating
unwanted background noise.
• Built in clock automatically imprints each file with the
date and time of creation.
• Built-in mono condenser microphone.
• Built-in speaker.
• Backlit LCD display.
• Remote jack for external start/stop control.
FOREWORD
This section must be read before any connection is made
to the mains supply.
WARNINGS
Do not expose the equipment to rain or moisture.
Do not remove the cover from the equipment.
Do not push anything inside the equipment through
the ventilation holes.
COPYRIGHT
Recording and playback of any material may require
consent. For further information refer to the following:
—Copyright Act 1956
—Dramatic and Musical Performers Act 1958
—Performers Protection Acts 1963 and 1972
—any subsequent statutory enactments and orders
INTRODUCTION
Please read these operating instructions carefully. We
recommend that you read the entire user guide before
you connect or operate the unit.
After you have reviewed the contents this manual, we
suggest that you make all system connections before you
attempt to operate the unit.
PRECAUTIONS
The following precautions should be considered when
operating the equipment.
When setting the equipment ensure that :
– air is allowed to circulate freely around the equipment
– the equipment is on a vibration free surface
– the equipment will not be exposed to interference from an
external source
– the equipment will not be exposed to excessive heat, cold,
moisture or dust
– the equipment will not be exposed to direct sunlight
– the equipment will not be exposed to electrostatic discharges
• In addition, never place heavy objects on the equipment.
• If a foreign body or water does enter the equipment, contact
your nearest dealer or service center.